User manual ENERGY SISTEM UNNIVERSAL 1100

[. . . ] Hold down " P+ " and " VOL­ " on the URC together simultaneously for 2 seconds until the indicator lights up. Press TV device mode key, then press " P+ " and " VOL­ " , and enter TV Magic Search Code 0001. Hold down " P+ " & " VOL­ " together simultaneously for 2 seconds until the indicator lights up, and your URC is ready to start searching. [. . . ] Use the number keys to enter your 4-digit Device Code, the indicator should go out immediately. TV) responds to your invoked function correctly, you have entered the right Device Code. Otherwise, repeat the above setup instructions with the rest available Device Codes until your device (e. * Simply repeat the above procedures to enter the Device Codes for your VCR, SAT, DVD or CTV. (Remember to press a correct Device Mode Key in step 2 above) Note : ­ DVD, CTV and other Device Codes can be entered into any device modes except "TV" & "VCR" modes. Just simply press the device mode key and enter your 4-digit device code for DVD, CTV and other devices. If the indicator flashes twice in step 4, a wrong Device Code has been entered. Suggestion : ­ If you cannot find a correct Device Code for your equipment, see 2 HOW TO SET UP THE URC­ By Searching Through the Library. ­ You are recommended to jot down your Device Codes in the space provided on back label after setting up the URC correctly for future reference. Note: ­ DVD, CTV and other device codes can be searched and locked into any device modes except "TV" & "VCR" modes. Just simply press the corresponding device mode key in step 2 & 5 and enter an appropriate Magic Search Code for your DVD, CTV and other devices. ­ Each time you press the " ", the URC will skip to the next code and send out a POWER signal trying to turn off your device. If you failed to stop pressing " " in time when your device has been turned off, turn on your device again immediately. Before the indicator goes out, press " " on the URC to skip backward. ­ If the indicator flashes twice after your pressing of " " key, you are already at the last code of the library. Press " P+ " and " VOL­ " to resume the URC and repeat carefully the above procedures to search again. [. . . ] Check whether your batteries are inserted properly and are in correct +/- marks. Check whether you have pressed the corresponding device mode key for your device. If several Device Codes listed under the brand of my A/V device, how can I select the correct Device Code? [. . . ]