User manual ENERGY SISTEM P1350

[. . . ] The device may stop to preserve integrity in such conditions but if you force P1350 to continue working it may cause damage and/or data loss to the unit. 2. MEDIA 2. 1 Internal hard disk Follow step-by-step the points below for a successful setup. Notice that some steps may vary depending on the operating system you use. Use 4 screws to fix the hard disk sure the HDD fits firmly into the holder. [. . . ] Taking into account all the previous points we recommend partitioning the disk into one FAT32 partition with 32 GB and (at least) one big NTFS partition. To prevent file system corruption remember to follow the correct steps when disconnecting P1350 from the computer: Windows: Use the `Safely remove hardware' procedure Mac OS: Discard the corresponding Desktop icon into Trash Bin before disconnecting P1350 from USB port. 30 2. 1. 4. 2 Windows 98/Me 1. Say yes to the message `Do you wish to enable large disk support (Y/N)?' by pressing [Y] and [Enter] 4. Change current fixed disk drive' by pressing [5] and [Enter] 31 5. Type the hard disk number for partitioning in `Enter fixed Disk Drive Number' and press [Enter]. Caution: if the computer has many hard disks connected make sure you select the appropriate number that corresponds to P1350. 6. Create DOS partition or Logical DOS Drive' by pressing [1] and [Enter] 7. Select option `1. Create primary DOS partition' by pressing [1] and [Enter] 8. Say yes to the message `Do you wish to use the maximum available size for a primary DOS partition and make the partition active (Y/N)?' by pressing [Y] and [Enter] 10. After it is completed, a `Primary DOS partition created, drive letters changed or added' message is displayed. Then press [Esc] to return to fdisk options screen. 12. In fdisk options screen press [Esc]. Then a message is displayed, saying that you must restart your system. Press [Esc] again 13. Type [exit] and [Enter] at the MS-DOS prompt to close the window 14. Disconnect P1350 from computer and then connect it again. Right­click the appropriate icon and select [Format] 16. When formatting is complete P1350 will be ready to use. 33 2. 1. 4. 3 Windows 2000/XP/Vista Note: there are slight changes in this procedure depending on the operating system version. Select [Start>Control Panel>Management Tools>Computer Management] and then [Disk Management] under [Storage] section 2. In the list of connected disks locate the one that corresponds to P1350 3. Activate the disk using MBR partition table (GUID partition table is not supported) if it is not already activated. Create a new partition by right-clicking an unallocated space in the disk and select [New partition] from the menu that appears 5. Assign a drive letter to the partition (you can accept the letter suggested by the wizard), click [Next]. 9. Select [Format this partition with the following settings]; FAT32 as [File system] and then check [Perform a quick format]. [. . . ] In this view you can browse the folders in the selected volume using the arrow buttons. 41 6. 4 Select media Choose the media from which P1350 plays files. If the internal hard disk is selected you have to choose one partition. The CF, SD/MMC/MS and/or USB icon will show if the corresponding external device is connected to P1350. 6. 5 File Copy Function Note that the destination folder must be hosted in a FAT32 partition (NTFS is not supported). First select the destination folder (that is, the folder you want the content be copied to) and press [Copy/ Target] button. [. . . ]