User manual ENCORE ENUCR DATA SHEET

[. . . ] This User's Manual will guide you through the successful installation of your new Encore Electronics® "ENUCR" Express Cam II into your computer. NOTE: Before you start, please make sure that there is no other web camera software and drivers installed on your computer. [. . . ] NOTE: Before you start, please make sure that there is no other web camera software and drivers installed on your computer. If you are replacing an old web camera please uninstall the software driver and the application software from the old device before proceeding to the next step. Click "Finish" to complete the installation wizard and restart computer Go to the Device Manager Utility Window and then go to "Imaging Devices ­ USB 2. 0 PC Camera". Go to the Control Panel (click START, move your mouse and click Control Panel) B. Click on the Device Manager button Step 2: Check the Express Cam II microphone settings Note: The following procedure is for the Express Cam II with microphone built-in only. Go to the "Control Panel" (Click "Start", move your mouse to "Control Panel" and click to select Open the "Sounds Audio Devices" Click on the "Audio" tab Under "Sound recording" section, select "USB Camera" from the drop Select File->Set Capture File. . . , assign folder and file name then click on open, Select CapturetoStart Captureand Stop Capture. Set video frequency at 60Hz or 50Hz and select Image Effects or Photo Frames which you like Software driver installation procedure: 1. If the video is not stable while in preview, from the menu bar click on "Options". From the Settings tab and under the "Flicker" section, set the frequency to either 60Hz or 50Hz whichever gives out better video screen. From the "AMcap" Window screen menu bar, select "Options", click to select "Video Capture Pin" a new Window "Stream Format" will appear, select the desired "Output Size" How to use Capture: 1. From the AMcap screen click on "Capture" ­ select "Start Capture". Check "Sounds and Audio Devices Properties" in Device Manager and make sure "Sound recording" default value is in USB Audio Device. Check your software's "Sound recording" , the value should be "USB Audio Device". [. . . ] From the AMcap screen click on "Capture" ­ select "Start Capture". Check "Sounds and Audio Devices Properties" in Device Manager and make sure "Sound recording" default value is in USB Audio Device. [. . . ]