User manual ENCORE ENUCM-012

[. . . ] Wait few seconds for the Found New Hardware Wizard screen to pop up, and then click "NEXT" 7. [. . . ] Click on the "Driver Setup", as seen on the picture below to start the installation wizard Hardware Installation Procedure: 1. Right after the Software and software driver installation, you may now insert or plug-in the Express Cam USB to the computer's available USB Port. Wait a few seconds and your computer will automatically detects the Express Cam and a message box appears on the lower right hand of the task bar next to the computers clock. Ignore this message and wait another few seconds for the Found New Hardware Wizard screen to pop up NOTE: In Windows® XP or Windows VistaTM you need not do anything, the computer will automatically install the necessary software driver from the previous install. For Windows 2000 and below the computer will ask for the driver disc while the hardware installation is in progress. 2. Make sure that the "Install the software automatically (Recommended)" is selected as shown on the picture below, and then click "NEXT" Frequently Asked Questions: >What should l do when videos drop or lag frames?WebCam supports "Auto White Balance" and "Auto Exposure". Your Express Cam will activate this function automatically when light is not sufficient. You can disable "Auto Exposure" if it causes slight delay problems. [. . . ] An installation bar would appear showing installation status, wait to finish copying files 4. Click "Finish" to complete the "Found New Hardware Wizard" [. . . ]