User manual ENCORE ENNHD-1000

[. . . ] GIGA Network Disk Drive Enclosure ENNHD-1000 User's Guide FCC Certifications ENNHD-1000 has been tested and found to comply with the limits for a Class A digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference when the equipment is operated in a commercial environment. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instruction manual, may cause harmful interference to radio communications. Operation of this equipment in a residential area is likely to cause harmful interference in which case the user will be required to correct the interference at his own expense. [. . . ] To open the Status page, click the Status on the configuration categories list. Items Host name IP-address HD used (%) Up-time Version Samba Users FTP Users UPNP & Printer Loaded Unicode Loaded Swap Enabled Information The identification of this device. The IP address of the device The usage percentage of HD (Total amount of HD) The estimate time that you power the device on The firmware version of the device. The number of members who is currently using the device by Samba The number of members who is currently using the device by FTP client Check if the file for triggering UPNP and Printer server is loaded. Check if the connected IDE interface HD is formatted with a partition for Swap function. Note: This page shows the device information only. To do more configurations about each item, please refer to their instruction respectively in the following chapters. 35 Disk The Disk page allows users to: 1. To open the Disk page, click the "Disk" on the configuration categories list Folder- Folder Configuration The folder configuration allows users to add folders, delete folders and change folder properties. To Configure Folder Properties Click on the folder that you are going to configure. 36 The folder configuration page shows up. Change folder-accessing authority level for users and groups. To change the folder name/ folder description 1. Click on "Change Folder Name" or "Change Description" icon. The Folder Name/ Folder Description Setting page shows up. 37 2. Fill in the new name or new description for the folder and click "Apply". You may click "Change" to do more configurations for this folder or click "Back" to return to folder list. Configure folder-accessing authority level for users and groups. Configure the access-permission rules for all users by pre-defined levels. Select one level and click "Save" to apply this authority for all users. The pre-defined levels use the following access permission rules: Pre-defined Levels Authentication Free Access: No access for all users: Only Read access for all users: Read/ Write access for all users: Current Access Permission for all users: Access Authority No authentication. Everyone is allowed to get access to this folder without username and password. The access permissions in "Group-Authority Setting" and "User-Authority Setting" will be applied to this folder. 38 2. Configure the access-permission rules by groups and users: Note: Before starting, you have to click "Current Access Permission for all users" in the "Please set user's limit for this folder". Select an access-permission rule for this group and click "Save" to apply. Click "Save" to apply. Tips: To do an efficient access-authority configuration, please refer to the following recommend procedures: Step1. (Ex, Click "No Access for all users" to configure all users as "Non-access" for this folder. 39 Step2. Step4. Click "Current Access Permission for all users" to allow configuration by groups or users. [. . . ] Click the button to start backup. To restore a back-upped file to your PC, select the file on the list and click to perform restoring. 69 Trouble Shooting 1. To shut down the System properly, press the Power button on the front panel for two seconds until Power LED blinks then go off. Make sure that your RJ-45 cable is connected with the device and your PC/Switch. Check your PC's IP address, make sure that it has a static IP or connects with a router with DHCP client. [. . . ]