User manual ENCORE ENHGS-224

[. . . ] FCC Certifications ENHGS-224 has been tested and found to comply with the limits for a Class A digital device, pursuant to part 15 of the FCC Rules. [. . . ] No part of this document can be copied or reproduced in any form without written consent from the company. Trademarks: All trade names and trademarks are the properties of their respective companies. Document Version: 2. 0 Introduction ENHGS-224 is a powerful, high-performance Gigabit Ethernet switch, where 24 ports of them are capable of 10/100Mbps and 2 ports capable of 10/100/1000Mbps with Full/Half duplex capability. Store-and-forward switching mode promises the low latency plus eliminates all the network errors, including runt and CRC error packets. To work under full-duplex mode, transmission and reception of the frames can occur simultaneously without causing collisions as well as double the network bandwidth. ENHGS-224 is plug-n-play without any software to configure and also fully compliant with all kinds of network protocols. Moreover, the rich diagnostic LEDs on the front-panel can provide the operating status of individual port and whole system. · · · · · One 24 port 10/100Mbps +2 port Gigabit Switch One power cord Rubber foot Rack-mount brackets and screws User's Manual 1 LED Definition Please refer to the following table for LED definition Type System Port 1~24 One LED Per port (10/100Mbps) LED Power Status Operation Steady Green Power is on Off Power is off LINK/ACT Steady Green The port is linking up Blinking Green There is traffic transverses the port Off No connection Steady Green Linking up 10M OFF No connection Steady Green Linking up 100M OFF No connection Steady Green Linking up 100M OFF No connection Steady Green There is traffic transverses the port OFF No traffic Port 25, 26 10M Four LEDs Per Port (10/100/1000Mbps) 100M 1000M Act 2 Installation AC Power ENHGS-224's power supply automatically adjusts to line power in the range 100-264V/ 50-60Hz. Cable Selection ENHGS-224 can use the following types of cabling: · · · 10BASE-T: Category 3, 4 or 5 UTP/STP 100BASE-TX: Category 5 UTP/STP 1000BASE-T: Category 5 UTP/STP Category 5 or enhanced cable is preferred to use with this product in structured wiring environments. [. . . ] 5 UTP/STP 100 meters 3 Network Application 4 Specifications Standard Interface IEEE802. 3, IEEE802. 3u, IEEE802. 3x, IEEE802. 3ab 24 * 10/100Mbps RJ-45 ports 2 * 10/100/1000Mbps RJ-45 ports (Auto MDI/MDI-X) RJ-45 (10BASE-T): Category 3, 4, 5 UTP/STP RJ-45 (100BASE-TX): Category 5 UTP/STP RJ-45 (1000BASE-T): Category 5 UTP/STP 10/100/1000Mbps 10Mbps Full/Half Duplex 100Mbps Full/Half Duplex 1000Mbps Full Duplex System Power Port 10/100M(24port): LINK/ACT 10M; 100M; 1000M; Act 2. 5Mbits 8K entries 10Mbps: 14, 880pps/14, 880pps 100Mbps: 148, 800pps/148, 800pps 1000Mbps: 1, 488, 100pps FCC Class A, CE 00 ~ 500C (320 ~ 1220F) 10% - 90% 3. 3V 4A (100-240V/ 50-60Hz) 61NB-5526D-200/C 5 Cable Connections Network Data Rate Transmission Mode LED indications System Buffer Memory MAC Address Table Filtering/Forwarding Rate Emission Operating Temperature Operating Humidity Power Supply [. . . ]