User manual EMTAC CRUX VIEW

[. . . ] Crux_View Test Program Manual (version 1. 6. 3) EMTAC Technology Corp. NOTE · · · · · This Crux_View Test Program is a trial version program and only for testing purpose. This Crux_View program is only for use with CRUX II / BTGPS and Pocket PC (PPC) with Bluetooth enabled. [. . . ] 2. 2 Pair and Connect the BTGPS with the PPC, if you did NOT have done this before. 2. 3 Execute `Crux_View' from `Start' menu on PPC. 2. 4 Click `Accept' to continue, if you accept the claim. 2. 5 Set `COM' to `COM8' for iPAQ 3870/3975; `COM4' for the PPC that with Socket's BT card. Set the `Baud' to `38400' bps. 2. 7 Click `Open' to connect to the BTGPS. Indicator and Function Buttons: Fix: The fix status, None, 2D or 3D; plus DGPS. 12-Channel Signal-Level View: The Signal Level in dB-Hz of each GPS channel. 2. 9 The Position Page. The `Unit' of the `Speed' can be select either in `knots' or `km/hr'. 2. 10 The Protocol Page. Set NMEA Update Rate: Click this button will send the NMEA update rate setting commands to BTGPS. The new update rate settings (seconds per message) were selected in left side pull down menus before click the `Set NMEA Update Rate' button. Switch to SiRF Binary Protocol 38400 bps: Click this button will switch the BTGPS to SiRF binary protocol in 3800 bps baud rate. Command Status: Indicate the status of sending commands. 2. 11 The Message Page. [. . . ] After changed the Power Mode, Click the `Apply' button to send the command to the BTGPS. Trickle Power Status: Display current power mode setting. 2. 14 The About Page. [. . . ]