User manual EMMALJUNGA SCOOTER

[. . . ] Always use the crotch strap in combination with the waist belt on the harness. Check that the vehicle body or seat unit attachment devices are correctly engaged before use. Accessories or spare parts that are not approved by the manufacturer shall not be used. Thevehicle shall be used only for up to the number of children for which it has been designed. [. . . ] iMPORTANT · The wheels are greased and can leave marks on textiles. Don't let your child play with or in some other way handle the plastic protections. Never leave the child unattended without engaging the braking system correctly. ⷠThe brake should always be engaged when you lift your child in and out of the vehicle. Check that there is a wheel cog on each wheel and that it is firmly attached. Assemble the tray by moving the catch which is on the underside of the tray slide under the rear axle. ⷠThen press the two ends into the holes on the chassis as indicated by the arrows. Make sure that the seat fabric's back pocket is attached correctly onto the backrest frame. After making sure, attach the Velcro tape on the inside of the back pocket (5). Always make sure that the backrest is in a safe position before it is used. Press both fabric armrests into position (7) over both sides of the seat unit. Affix the foot piece on the seat fabric with the press studs that sit under the seat fabric. Place the front bar protection cover (8) over the front bar and close the zip fastener. How to use the vehicle Unfolding the vehicle You can unfold the vehicle in two ways: · Start by lowering the backrest forwards towards the front bar or by lowering the backrest backwards. Then lower the chassis by pulling the two chassis locks (one on each side of the vehicle) upwards. No child is to be placed in or nearby the vehicle when folding or unfolding the vehicle. Lift up the safety catch (on the right hand side) and push the handle forwards. If the wheels are taken off, the vehicle will take up even less space · To make the vehicle more compact, remove the wheels by pressing in the wheel hub's release button and then pull off the wheel. iMPORTANT · Wipe off any dirt or grease from the axles before you replace the wheels. Keep the buttons pressed in while you adjust to the required position (14). Adjust the hood by gently pulling the front backwards and forwards until it reaches the desired position. Adjust the height of the hood (15) by pulling/pushing it carefully up or down on the handle. [. . . ] Tyres can when in contact with PVC-floor or other plastic materials cause discoloration. Only wipe the 5-point nylon harness and plastic parts clean with a damp cloth. ⷠFront bar and front bar protection cover: Remove the cover from the front bar. Use mild liquid soap as detergent on the surface of the exterior fabric on the front bar. [. . . ]