User manual EMERSON HD7005

[. . . ] Sales receipt required as proof of purchase for warranty claims. GENERAL SAFETY INSTRUCTIONS Safety Signal Words DANGER: means if the safety information is not followed, someone will be seriously injured or killed. WARNING: means if the safety information is not followed, someone could be seriously injured or killed. CAUTION: means if the safety information is not followed, someone may be seriously injured or killed. To reduce the risk of fire or shock hazard, plug humidifier directly into a 120V, A. C. [. . . ] Place the opening of the water bottle under a water faucet (the bottle should fit under a four-inch clearance faucet). Press up on valve cap plunger for about one second to let out a little water. If you hear air bubbles or see leaks, retighten cap and check for leaks again. NOTE: If either the fill cap or the valve cap leaks, water may overflow and leak out the rear vents of the cabinet. For proper operation, the "E-Z-Fill Side-Cap" must be facing the center of the cabinet. When positioned properly, the plunger will open and water will flow into the cabinet. The water level will automatically remain at approximately 1" until the bottle is empty. The unit is now ready for operation. Turn Counterclockwise to Remove "E-Z-Fill Side-Cap Valve Cap Plunger 6 Operating Humidifier Controls The operating controls of your Emerson evaporative humidifier are located on the top right of the humidifier. The controls are found under the smoked cover Lift the control cover by placing your finger in the round cutout and lifting. Familiarize yourself with the controls and their functions as described below. Fill Light When the unit has a small amount of water left in it, the fill light will come on and the unit will automatically shut off. Humidity Control: Adjust the amount of humidity depending on your needs. The humidifier will turn on and off as required to maintain level of humidity selected. A medium setting (midway between and ) is recommended, but there are times when a low or high amount of humidity may be preferred. For constant operation of humidifier, rotating knob all the way clockwise allows for the maximum amount of humidity to be evaporated into the air continuously. IMPORTANT: Water damage may result if condensation starts to form on windows or walls. Humidity Control setting should be lowered until condensation no longer forms. Air Flow (Speed) Control The unit is adjusted from OFF " " to high " " with a three speed rotary control. The higher the air flow speed, the more water is evaporated and released into the air. Low speed " " is the quietest and is provided for conditions that may not require as high an evaporation rate. 7 Using Your Humidifier 1. If humidifier stops running and the Fill Light is not illuminated, the humidity level is at the normal requirements for that setting or it is adjusting to the home conditions. The table below shows relative humidity percentages which are recommended at various outdoor temperatures. The figure below shows approximate relative humidity percentages which correspond to the various settings of the Humidity Control When Outdoor Recommended Indoor Temperature is: Relative Humidity is: -10°F 0°F 10°F 20°F & above Rel. Set Humidity Control position (halfway between NOTE: Humidifier should operate with humidity control on the recommended medium setting (midway between and ). To test the unit under this condition, turn Humidity Control all the way to clockwise and unit should begin to operate. After the unit has been tested, set Humidity Control to medium or desired level. [. . . ] · Ensure gaskets for "E-Z-Fill Side Cap" are in place (see repair parts list). Reposition so that bottle cap plunger is depressed by post in bottom of cabinet. (Some carpet padding may allow unit to set lower on the left side than the right side due to the weight of the water bottle on the left side. · Clean humidifier as instructed in your Owner's Manual · Replace filters and use an EPA Approved Bacteriostat. [. . . ]