User manual EMERSON HD60002

[. . . ] ATTACHMENTS - Do not use attachments not recommended by the TV manufacturer as they may cause hazards. WATER AND MOISTURE - Do not use this TV near water, for example, near a bath tub, wash bowl, kitchen sink, or laundry tub, in a wet basement, or near a swimming pool, and the like. ACCESSORIES - Do not place this TV on an unstable cart, stand, tripod, bracket, or table. The TV may fall, causing serious injury to someone, and serious damage to the appliance. [. . . ] , between antenna and CATV) or if you move the unit to a different area after the initial setting, or if you recover the DTV channel you deleted, you will need to perform auto channel scan. If you press [POWER] or [MENU] during "AUTO PRESET CH", the setting will be canceled. When no channel can be received by "AUTO PRESET CH", "NO TV SIGNALS" is displayed on the TV screen. With regard only to the digital channel, even after the scanning is complete if you unplug the AC power cord before turning off the unit by pressing [POWER], the channel setting may be lost. Use [CH K / L] to select "CHANNEL SETUP", then press [VOL X]. You can choose English, Spanish, or French as your on-screen language. Use [CH K / L] to select your desired preset type, then press [VOL X]. When the scanning and memorizing are completed, the lowest memorized channel will be displayed. When you selected "AUTO PRESET CH (TV/DTV)", the lowest memorized analog channel will be displayed when the scanning and memorizing are completed. The mute function, which turns the sound off and on, is also described. - When selecting digital channel 12-1 Be sure to press [­/ENT] before entering the minor channel number. When you disconnect the unit from the AC outlet or when a power failure occurs, the sleep timer setting will be canceled. [ZOOM] Enlarge and display the center area of the digitalsupported program. The channel add/delete function lets you add the channel that was not added by the auto channel scan due to the reception status at the initial setting. Use [CH K / L] to select "CHANNEL SETUP", then press [VOL X]. In the digital mode (DTV), you can add or delete channels only for major channel. Once you delete a DTV channel, you cannot recover the channel without performing auto channel scan again. Use [CH K / L] to select "ADD/DELETE(DTV)" or "ADD/DELETE", then press [VOL X]. Closed caption refer to text of dialogue or descriptions displayed on-screen for the hearing impaired. 3 Use [CH K / L] to select the picture quality type you The captioning or text is displayed in the same language as the program's dialogue (up to 4 lines of script on the TV screen, where it does not obstruct relevant parts of the picture). CAPTION2 (C2) and TEXT2 (T2); are rarely available and broadcasters use them only in special conditions, such as when "CAPTION1" or "TEXT1" is not available. There are 3 display modes according to programs: Paint-on mode: Displays input characters on the TV screen immediately. [. . . ] Read the description in this owner's manual for more details on correct operations. Wipe the front panel and other exterior surfaces of the unit with a soft cloth immersed in lukewarm water and wrung dry. If the remote control is not working properly, you can use an AM radio or digital camera (including a cellular phone with built-in camera) to see if it is sending out an infrared signal. With a digital camera (including built-in cell phone cameras): Point a digital camera towards the remote control. [. . . ]