User manual EMERSON HD13030

[. . . ] To reduce the risk of fire hazard, never put the electric cord under rugs, near heat registers, radiators, stoves or heaters. Always unplug the humidifier before moving it, before cleaning, or whenever the humidifier is not in service. Never use your humidifier while any part is missing or damaged in any manner. To reduce the risk of electrical hazard or damage to humidifier, do not tilt, jolt or tip humidifier while unit is running. [. . . ] If the unit is positioned close to a window, condensation may form on the window pane. If this is not acceptable, the unit should be repositioned in another location. NOTE: Due to release of cool, moist air from humidifier, it is best to direct air away from home thermostat and hot air registers. Hot air registers and cold air from outside walls can affect the efficiencies of the controls. Unit should not be placed where warm air from a hot air register blows directly on unit. The humidifier should be positioned with the back (cord exit side), at least 2 inches away from the wall. Air needs to enter through louvers in the rear panel in order for the humidifier to operate at peak efficiency. At Least 2" From Wall Water Fill WARNING: To reduce the risk of shock, always unplug humidifier before cleaning or servicing. WARNING: To reduce the risk of fire or shock hazard, do not pour or spill water into control or motor area. If controls get wet, let them dry completely and have unit checked by an authorized service personnel before plugging in. This humidifier is designed for use with the water bottle located under the bottle cover to the left of the fan assembly. The unit should be positioned where it will be operating. Water Bottle Bottle Cover 5 Water Fill (continued) To fill this humidifier, close the control cover and remove the bottle cover. To test the unit under this condition, turn Humidity Control all the way to clockwise and unit should begin to operate. After the unit has been tested, set Humidity Control to medium or desired level. If humidity level in home is sufficient, the humidifier will only operate with Humidity control set on or near position. IMPORTANT: Water damage may result if condensation starts to form on windows or walls. HUMIDITY control setting should be lowered until condensation no longer forms. 20% 25% 30% 35% Humidity Rel. Rel. Humid ity RELATIVE HUMIDITY Operating Tips for Best Performance 1. Position the humidifier at least 2 inches from any wall and away from any heat registers. Use liquid EPA-approved bacteriostat to retard bacteria growth that may cause odors and may be harmful to your health. Regular cleaning as instructed in "Cleaning Your Humidifier" section of this manual is recommended. Replace the evaporative wicking filters at least once per humidification season or more depending on water conditions in your area. 8 Replacement and Care of Filters WARNING: To reduce the risk of shock or injury from moving parts, always unplug humidifier before removing or replacing any parts. CAUTION: To help retard bacteria growth and keep maximum efficiency, the filters should be replaced at least once a season, or more often under hard water conditions. [. . . ] "Bi-Weekly Maintenance" is also recommended if you do not plan to run the humidifier for one week or more. CAUTION: Use liquid EPA-approved bacteriostat available from your local retail store. Under no circumstances should you use water treatment products designed for Roto belt or Ultrasonic humidifiers. 12 Troubleshooting TROUBLE PROBABLE CAUSE REMEDY · Turn speed control clockwise. out completely. · A small amount of water remains in the cabinet after fill light comes on. · Check "E-Z-Fill Side-Cap" and valve assembly cap to ensure tightness. [. . . ]