User manual EMERSON FANS PROVENCE

[. . . ] READ AND SAVE THESE INSTRUCTIONS "Provence" Series Model No. CF2300TG01 CF2300S01 CF2300OB01 CF2300WB01 Net Weight: 23. 8 Lbs. ® Provence Series Ceiling Fan Owner's Manual Part No. BP7217-1 ! WARNING WARNING: To avoid fire, shock, and serious personal injury, follow these instructions. Safety Instructions 1. Read your owner's manual carefully and keep it for future reference. Before servicing or cleaning unit, switch power off at service panel and lock service panel disconnecting means to prevent power from being switched on accidentally. [. . . ] Using the wire connector supplied, connect the uplight yellow lead assembly to the yellow lead from the fan motor and housing assembly (Figure 16). 4" UPLIGHT YELLOW LEAD ASSEMBLY CUT HERE Figure 16 9. Install the setscrew (supplied in loose parts bag) in the motor coupling and tighten using the 5/32" setscrew wrench (supplied) (Figure 17). DOWNROD Figure 15 3" DOWNROD 7. Fold the yellow, red, and brown wires into the slot in the motor coupling, slide the downrod down the wires and seat the downrod in the motor coupling (Figure 16). Align the clevis pin holes in the downrod with the holes in the motor coupling. The clevis pin must go through the holes in the motor coupling and the holes in the downrod . Push the straight leg of the hairpin clip through the hole near the end of the clevis pin until the curved portion of the hairpin clip snaps around the clevis pin. The hairpin clip must be properly installed to prevent the clevis pin from working loose. Pull on the hanger ball to make sure the clevis pin is properly installed. SETSCREW Figure 17 10. Screw two 1" threaded studs (provided) into the motor (Figure 22). Slide the motor cover over the downrod and rotate the cover until the threaded studs protrude; install two knurled knobs (supplied) to secure the cover. 8 NOTE: Make sure the red and brown leads are capped with wire connectors. Make sure red, brown, and yellow wire connectors are completely inside motor coupling cover and not pinched between the motor coupling cover and motor. 14. Use three 10-32 x 3/8" pan head screws and flat washers (supplied) to secure flange to blade (Figure 20). Repeat for the remaining four blades. BLADE FLANGE KNURLED KNOB MOTOR COUPLING COVER WIRE CONNECTOR YELLOW LEADS 1" THREADED STUD 7/8" FLAT WASHER (3) 10-32 x 3/8" PAN HEAD SCREW (3) WIRE CONNECTORS BLADE RED LEAD BROWN LEAD MOTOR Figure 20 Figure 18 11. Be sure the cover is oriented correctly, with the large opening at the top (Figure 19). Route the motor leads through the hanger ball and slide the hanger ball over the downrod (Figure 19). Install the pin through the holes at the top of the downrod and slide the hanger ball up the downrod, aligning the ball so the pin is captured in the groove in the top of the hanger ball. Pull the hanger ball up tight against the pin and securely tighten the setscrew in the hanger ball. Use the 10 round recessed holes in the motor hub marked with "5" and install the five blade assemblies (ordered separately) in accordance with Step 16. Attach one blade assembly to the motor hub using two 10-32 x 5/8" oval head screws (supplied) (Figure 21). Gently snug all flange screws to the motor hub, working around the hub in a clockwise sequence. Next, securely tighten all flange screws, again working in a clockwise sequence. This completes the blade installation. MOTOR HUB WARNING It is critical that the pin in the hanger ball is properly installed and the setscrew securely tightened. [. . . ] Capacitor Harness Screw, #8 Washerhead 8-32 x 3/8" (4) Uplight Lead Assembly Owner's Manual CF2300S01 761655-16 -- -- -- 761620-24 760601 * 761522-2 761506-10 761621-16 762304 761629-1 -- -- -- -- -- -- -- -- -- -- -- -- -- -- -- 761517-4 -- -- -- -- -- 761453 761505-1 -- 761790 BP7217-1 Provence Models CF2300OB01 CF2300WB01 761655-9 -- -- -- 761620-9 760601 * 761522-4 761506-12 761621-9 762304 761629-1 -- -- -- -- -- -- -- -- -- -- -- -- -- -- -- 761517-5 -- -- -- -- -- 761453 761505-1 -- 761790 BP7217-1 761655-19 -- -- -- 761620-26 760601 * 761522-3 761506-13 761621-17 762304 761629-1 -- -- -- -- -- -- -- -- -- -- -- -- -- -- -- 761517-6 -- -- -- -- -- 761453 761505-1 -- 761790 BP7217-1 CF2300TG01 761655-13 -- -- -- 761620-23 760601 * 761522-5 761506-9 761621-13 762304 761629-1 -- -- -- -- -- -- -- -- -- -- -- -- -- -- -- 761517-3 -- -- -- -- -- 761453 761505-1 -- 761790 BP7217-1 1 2 3 6 7 8 9 10 13 23 4 5 11 12 14 15 16 17 18 19 20 21 22 32 34 24 25 26 27 28 29 30 31 33 35 -- 14 LIMITED WARRANTY What The Warranty Covers: This warranty covers the motor and the other components and accessories of your Emerson ceiling fan against all defects in workmanship and materials. You must be the original purchaser or user of the product to be covered. What The Period Of Coverage Is: As it applies to the motor, this warranty will last for the lifetime of your ceiling fan. All other components and accessories are covered by this warranty for one year from the date you purchased your ceiling fan. [. . . ]