User manual ELK PRODUCTS ELK-1RT

[. . . ] Speaker & Stainless Steel Enclosure ELK-1RT The ELK-1RT is a rugged 30 Watt, 8 Ohm speaker mounted in a tamper resistant, "No Rust" enclosure. [. . . ] Tamper: Sealed Reed Switches. Components of ELK-1 RT Back Plate w/ (2) Tamper Switches Features and Specifications subject to change without notice. Hardware Pak PO Box 100 · Hildebran, NC 28637 · 800-797-9355 · 828-397-4200 Fax 828-397-4415 · www. elkproducts. com · info@elkproducts. com 05/02 ELK PRODUCTS, INC. Instructions Wall Mounting Holes Electrical Box Mounting Holes ELK-1RT The ELK-1RT is a rugged, quality speaker mounted in a tampered "No Rust" stainless steel enclosure. It incorporates two sealed reed tamper switches for enhanced reliability and ease of use. Install top edge of backplate at least 1" below any soffit or building overhang. 1. Wire / Conduit Entry Using the backplate as a template, mark and drill the 4 mounting holes and the wire or conduit entry hole (see Figure 1). Insert the (4) 1/4 x 1" wall anchors, then partially install the top two #10 x 1" screws. Route the wire or conduit through the hole provided and hang backplate on the top screws. Temporarily hang the speaker on the backplate by aligning the slotted insert on the top edge of the speaker with the 1/2" recessed tab on the bottom edge of the backplate. (See Figure 2) Connect the two white wires from the tamper switches to a 24 hour closed loop on the control panel (the switches are already connected in series). Connect the red and black speaker wires to an 18 gauge (minimum) cable run back to the siren driver in the control panel. Move the speaker from its hanging position to its final mount by aligning it's top and bottom slots with the 1/2" tabs on the top edge of the backplate and in the bottom center above the bolt threads. [. . . ] If possible, test the operation of the tamper switch using a continuity meter. 2. Figure 1 3. TAMPER White TAMPER White SPEAKER LEADS Black Red 4. ELK-901G 5. 6. Figure 2 7. Tuck wires into lower corner of backplate away from top inside corners. 8. Figure 3 Tamper switch is closed by the front cover during the final 3 to 4 turns of the hex bolt. Slide over speaker. Lower tabs into slots. Push towards wall. Figure 4 Lift up to lock, then secure with hex bolt. [. . . ]