User manual ELK PRODUCTS ELK-150RT

[. . . ] Siren & Stainless Steel Enclosure ELK-150RT The ELK-150RT is a self-contained Siren in a tampered "No Rust" stainless steel enclosure. It features two sealed reed tamper switches, one on the Back plate and one on the Front Cover. The ELK-150RT can produce two distinct sounds from a single input trigger. [. . . ] Size: 5"H x 5"W x 4"D. Back Plate w/ (2) Tamper Switches Hardware Pak Features and Specifications subject to change without notice. PO Box 100 · Hildebran, NC 28637 · 800-797-9355 · 828-397-4200 Fax 828-397-4415 · www. elkproducts. com · info@elkproducts. com 05/02 ELK PRODUCTS, INC. Instructions Install top edge of backplate at least 1" below any soffit or building overhang. Wall Mounting Holes Electrical Box Mounting Holes ELK-150RT INSTALLATION OF THE ELK-150RT SIREN The ELK-150 RT is a self-contained siren in a tampered "No Rust" stainless steel enclosure. It incorporates two sealed reed tamper switches for enhanced reliability and ease of use. Using the backplate as a template, mark and drill the 4 mounting holes and the wire or conduit entry hole (see Figure 1). Insert the (4) 1/4 x 1" wall anchors, then partially install the top two #10 x 1" screws. Route the wire or conduit through the hole provided and hang backplate on the top screws. Temporarily hang the Siren/speaker on the backplate by aligning the slotted insert on the top edge of the Siren with the 1/2" recessed tab on the bottom edge of the backplate. (See Figure 2) Connect the two white wires from the tamper switches to a 24 hour closed loop on the control panel (the switches are already connected in series). Connect the Red (+) and Black (-) wires from the Siren to the control's alarm output. This ComboTriggerTM feature allows two sounds to be activated by a control that has only a single alarm output with a pulse option. NEG (-) Black = Negative (-) terminal from Control's Alarm output. = Positive (+) terminal from Control's Alarm output 2. Wire / Conduit Entry 3. Figure 1 4. 5. TAMPER LEADS White White ELK-901G ELK-901G POWER to SIREN Black Red ELK-901G ELK-901G ELK-901G YELP (+) RED Figure 2 6. NOTE: The Siren is factory set for maximum loudness and current draw. To change the unit for lower current draw and loudness, remove the four screws and cover from the back of the siren. Find the Red speaker wire and follow it to where it solders to the circuit board. [. . . ] Note: The ELK-150RT is designed for Single Output Alarm Controls that use a STEADY Output for BURG or a PULSING Output for FIRE. For an Alarm Control panel that has separate BURG and FIRE alarm outputs connect the Red wire to each output, then program one output for Steady(Burg) and the other for Pulsing(Fire). Connect the Black wire to Neg. 7. Tuck wires into lower corner of backplate away from top inside corners. 8. Figure 3 Slide over speaker. Lower tabs into slots. Push towards wall. Tamper switch is closed by the front cover during the final 3 to 4 turns of the hex bolt. Lift up to lock, then secure with hex bolt. Figure 4 [. . . ]