User manual ELECTRO-VOICE RE-97 TX DATASHEET

[. . . ] RE97Tx Micro-Headworn Condenser Microphone with TA4F Connector Key Features: · · · · · Ultra-Low Profile for Inconspicuous Use Lightweight, Durable Interchangable for Left or Right Ear Omnidirectional Polar Pattern Provides Clean Sound and Uniform Response Integrated RFI Suppression General Description: The Electro-Voice RE97Tx is an Ultra-low profile, omnidirectional, back-electret condensor headworn microphone designed for use with standard EV and Telex belt packs. [. . . ] It is wired for use with standard EV and Telex belt packs including the EV (BPU-2/CSB-1000) and Telex (WT-500/WT-1000) bodypack transmitters and operates from a 5VDC supply. Connector Wiring: Pin #1 ­ Ground, Shield Pin #2 ­ Audio, White Pin #3 ­ Bias Voltage, White Pin #4 ­ N/C Accessories Furnished: Windscreen Clothing Clip Gig Bag Color: Beige, Tan, Black Net Weight: 0. 6 oz. (5. 7g) Application Notes: Figures 1 through 3 show the ideal position of the microphone in use. The end of the boom should be located approximately ¼" (6. 5mm) to ½" (13mm) back from the corner of the mouth and as close to the face as possible. This position will optimize the signal to noise ratio as well minimize the acoustic effects of breath noise. Figure 1 Figure 2 Figure 3 The microphone cable is routed behind the neck of the user and secured in place with the supplied clothing clip as shown in Figure 4 and 5. Allow some slack in the cable to enable the user's head complete range of motion in both directions without pulling the cable from the clothing clip. Fitting: Figure 4 Figure 5 1. Before placing the microphone over the user's ear, apply a slight bend to the boom, starting at the base of the earhook, to aid the microphone boom in forming to the user's face. Figure 6 Figure 7 The boom can be easily straighten by pinching between the thumb and forefinger, and applying pressure as your fingers slide away from the earhook. The boom and can be reshaped countless times without ill effect on the performance of the microphone or degradation of the mechanical structure. Figure 8 2. Press on the earhook from all sides to form it to the contour of the ear. [. . . ] For customer orders, contact Customer Service at: + 1 952 884-4051 Fax: + 1 952 736-4212 For warranty repair or service information, contact the Service Repair department at: 800/553-5992 or 402/467-5321 For technical assistance, contact Technical Support at: 800/392-3497 or 952/736-4656 Specifications subject to change without notice. [. . . ]