User manual ELECTRO-VOICE DL12SB

[. . . ] The excursion of the DL12X at these frequencies is much reduced compared to sealed or open-back enclosures, directly reducing harmonic distortion and the possibility of speaker bottoming. Vented-enclosure recommendations follow, some incorporating low-frequency equalization. Thiele-Small parameters are provided so designers can tailor the response to suit their needs. The 1. 8-cubic-foot enclosure tuned to 55 Hz has a smooth extended response to below 50 Hz. [. . . ] The cone has a moisture-repellent treatment, allowing it to be used in harsh and humid conditions. (Do not expose the cone to direct water or sunlight. ) The DL12X is a true high-fidelity woofer in every sense, being capable of high output, low distortion and solid bass response. DIRECTIONAL CHARACTERISTICS The directional characteristics of the DL12X in a 1. 1-cubic-foot vented enclosure were measured in Electro-Voice's large anechoic chamber. The test signal was one-third-octave filtered pink noise centered at the frequencies indicated. A full spherical measurment system, which is completely compatible with the AcoustaCADDTM computer-aided design program, was used. Beamwidth is the angle at which the horizontal and vertical polar responses have decreased in level by 6 dB when compared to the axial frequency response. The directivity factor R (Q) is the relative value, at a point, of the DL12X when compared to an ideal spherical response. The directivity index, Di, is calculated by the formula: Di = 10 log10 R. TYPICAL AMPLIFIER SIZE 300-600 watts per woofer is the optimal amplifier size. Amplifiers of this size will allow maximum output with minimal risk of speaker damage when properly used. Smaller amplifiers can also be used with excellent results--the full capabilities of the speaker will simply not be used. The stepdown equalization described in the Step-Down Operation section provides the required protection. If step-down equalization is not used, the Electro-Voice EX-24, XEQ-2 and XEQ-3 electronic crossover/equalizers can also provide subpassband protection. The 3-dB-down points are 30 Hz (EX-24 and XEQ-2) and 16 Hz or 32 Hz (XEQ-3). Other high-pass filters are available and onethird-octave equalizers can also be effective at providing the required protection. USE IN MULTIPLES Cone loudspeakers may be stacked for greater acoustic output and a narrower beamwidth. ) At relatively low frequencies (below about 150 Hz for typical enclosures) stacking produces additional acoustic output without altering dispersion. When a common signal is applied, a 6dB increase in maximum acoustic output is possible. This increase occurs because the cones "mutually couple, " acting as one cone with twice the area (therefore, twice the efficiency) and twice the power-handling capacity of a single cone. This mutual coupling occurs when the frequency is such that the center-to-center distance between the two woofer manifolds is less than about one-half wavelength. MOUNTING The DL12X may be front- or rear-mounted against either surface of its mounting flange and requires a 279 mm (11. 0 in. ) diameter cutout and a 294 mm (11. 56 in. ) bolt circle. Normal fasteners up to 6 mm (1/4 in. ) will fit through the eight holes in the frame. Front mounting is simplest using the optional SMH-1 speaker mounting kit. [. . . ] Obtaining Warranty Service: To obtain warranty service, a customer must deliver the product, prepaid, to Electro-Voice or any of its authorized service representatives together with proof of purchase of the product in the form of a bill of sale or receipted invoice. A list of authorized service representatives is available from Electro-Voice at 600 Cecil Street, Buchanan, MI 49107 (616/695-6831 or 800/ 234-6831). Incidental and Consequential Damages Excluded: Product repair or replacement and return to the customer are the only remedies provided to the customer. ElectroVoice shall not be liable for any incidental or consequential damages including, without limitation, injury to persons or property or loss of use. [. . . ]