User manual EIZO I·SOUND L2

[. . . ] 15 LIMITED WARRANTY . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 17 2 PRECAUTIONS General CAUTION · Remove the sound unit whenever moving the monitor. It may result in injury or equipment damage. · When adjusting the viewing angle of the monitor, do not do so by the sound unit. Adjusting the monitor by the sound unit may dislodge it from the LCD monitor or result in accidental pinching of the skin. [. . . ] · HEADPHONE: Headphones jack A set of headphones is a great tool to work without disturbing people within a close range. When using the headphones, the speakers will not channel any audio information. · VOLUME: Volume control dial A volume control dial is provided to alter the sound level from the speakers or the head phones. · LINE IN: External input jack Please use this connection for external devices such as audio peripherals, computers, sound boards to input sound to be heard through the speakers or headphones. 8 2. INSTALLATION · Always switch the monitor off before installing or removing the sound unit and whenever connecting or disconnecting any other devices to the sound unit. E How to connect external audio devices and the computer 1. Turn off the LCD monitor and remove the power terminal cover as shown below. Pull up the power terminal cover with your finger, and gently slide the power terminal cover into the groove of the LCD monitor. Do not touch the power terminal with your finger. Rear Power Terminal Cover Pull up the power terminal cover with your finger, and gently slide the power terminal cover into the groove of the LCD monitor. 9 2. Place the sound unit under the monitor screen and insert the hooks `a' on top of the unit into slots `a' located at the bottom of the rear of the monitor. Slide the unit into place by pulling softly from side to side, and hook `b' will snap into slot `b'. · To remove the sound unit from the monitor, please hold the unit and press on hook `b' and slide the sound unit softly with both hands. 10 3. · Please use the enclosed Stereo Mini-jack Cable (or another cable with the same specifications) for connecting audio devices or computers to the unit. When connecting two audio devices to the unit, please purchase another Stereo Mini-jack cable. Connect the headphone jack (or a line out jack) of the device (or a computer) to the LINE IN jack of the sound unit using the Stereo Mini-jack Cable. Insert the power cord and signal cable into the cable holder of the height adjustable stand. E To Computer or Graphics Board Cable Holder 11 Speakers and sound control 1. Besides the speakers on its unit, audio performance is available by connecting the headphones to the i× Sound L2 unit (When headphones are connected, no sound can × be heard from the speakers. ) HEADPHONES 2. Please use the volume control to adjust to the desired sound level. DECREASE INCREASE 12 3. TROUBLESHOOTING This page presents problems that can be corrected by the user. If a problem persists even after applying the suggested remedies, contact an EIZO dealer. Problems · No sound Points to check with possible solutions Check that the monitor is turned ON. [. . . ] (b) Any deformation, discoloration, warping or whatsoever due to normal deterioration of the product. (c) Any incompatibility of the products with subsequent technical innovations or regulations. (e) Any defect of the product on which the original serial number has been altered or removed. To obtain service under this warranty, the original purchaser must deliver the product, freight prepaid, in its original package or other adequate package affording an equal degree of protection, assuming the risk of damage and/or loss in transit, to your local EIZO authorized distributor. [. . . ]