User manual EIZO FP-1501

[. . . ] Note · Please be careful not to scratch the LCD panel or the cabinet with the panel protector during installation. [. . . ] In this condition, the panel protector might become bend or slip out from the monitor. Installation Before installation, please remove dust and stains from the LCD panel. 1. (2) 2. (1) Lever 1. Set the panel protector into the grooves of the panel frame; the lower first (1), then the upper (2). With the enclosed tool (Lever) set the tabs of the panel protector into the side grooves (2 tabs). Put the lever on the tabs of the panel protector and move it toward the LCD panel to install. Position the protector into the LCD panel tightly without leaving an opening. Removing Put the lever on the tabs of panel protector and move it toward the cabinet to remove. Cleaning Note · Please be sure to keep the panel protector immobilized while cleaning it. To hold the panel protector by hand, use a soft cloth to avoid dust or finger prints. · Never use thinner, benzene, alcohol (ethanol, methanol, or isopropyl alcohol), abrasive cleaners, or other strong solvents, as these may cause damage to the cabinet or panel. The panel surface can be cleaned with a soft cloth such as cotton or lens paper. If necessary stubborn stains can be removed by moistening part of the cloth with water to enhance its cleaning power. [. . . ] 70 g Lever (for Panel Protector), User's Manual Copyright© 2007 EIZO NANAO CORPORATION All rights reserved. 00N0L354A1 (U. M-FP1501) [. . . ]