User manual EIZO FLEXSCAN T566

[. . . ] User's Manual FlexScan T566 Color Display Monitor Important , Please read this User's Manual carefully to familiarize yourself with safe and effective usage procedures. Please retain this manual for future reference. English SAFETY SYMBOLS This manual uses the safety symbols below. Please read them carefully. WARNING Failure to abide by the information in a WARNING may result in serious injury and can be life threatening. CAUTION Failure to abide by the information in a CAUTION may result in moderate injury and/or property or product damage. Indicates a prohibited action. Indicates to ground for safety. Copyright© 2002 by EIZO NANAO CORPORATION. [. . . ] In the following cases, the signal given preference will be displayed automatically. · Once a priority is selected in the <Input Priority> function, whenever a change of signal is detected at the selected input, the monitor will switch the input to that signal. [How to give priority to the input] (1) Select <Input Priority> in the <Others> menu. (2) Select <Auto> and set BNC or D-Sub input. Saving the adjustment data The adjustment data can be saved for both signals. However, the following adjustment and setting data can be saved for each input signal (BNC/D-Sub). <Contrast>, <Fine Contrast>, <Temperature>, <Custom> and <sRGB> 20 3. TROUBLESHOOTING If a problem persists even after applying the suggested remedies, contact an EIZO dealer. *The bracket < > indicates the function of ScreenManager Problems 1. No picture · Indicator status: Off Points to check with possible solutions Check that the power cord is correctly connected. If the problem persists, turn off the monitor power for a few minutes, then turn it back on and try again. 18) Try pressing the AUTO/FINE MODE button or control pad or turn the monitor off and then on. 19) These messages appear when the signal is not input correctly, even if the monitor functions properly. When the image is displayed correctly after a short time, it is not a monitor's problem. Check that the signal cable is properly connected to the PC or graphics board. Switch the signal input by pressing the BNC/D-Sub selection button on the front control panel. Use the graphics board's utility software to change the frequency setting. (Refer to the manual of the graphics board). · · · Indicator status: Green Indicator status: Flashing Green Indicator status: Flashing Yellow 2. (Error messages shown below will remain on the screen for 30 seconds. ) · "No signal detected" error message appears. · "Out of range" error message appears. Whenever an error signal message appears, the signal frequency will be displayed in red. The image vibrates on the screen. Points to check with possible solutions Check that the signal cable is correctly connected to the PC or graphics board. The monitor may be located close to a device that is generating a magnetic field. Such devices include speakers (other than the EIZO optional iSound speaker), electric motors, high-voltage cables, and other monitors. [. . . ] It also demands that mercury is not present in any of the electrical or electronics components associated with the labelled unit. CFCs (freons) The relevant TCO'99 requirement states that neither CFCs nor HCFCs may be used during the manufacture and assembly of the product. CFCs break down ozone and thereby damage the ozone layer in the stratosphere, causing increased reception on earth of ultraviolet light with e. g. Lead** Lead can be found in picture tubes, display screens, solders and capacitors. [. . . ]