User manual EIZO FLEXSCAN T565

[. . . ] Please read them carefully. WARNING Failure to abide by the information in a WARNING may result in serious injury and can be life threatening. CAUTION Failure to abide by the information in a CAUTION may result in moderate injury and/or property or product damage. Indicates a prohibited action. Indicates to ground for safety. Copyright© 2001 by EIZO NANAO CORPORATION. No part of this manual may be reproduced, stored in a retrieval system, or transmitted, in any form or by any means, electronic, mechanical, or otherwise, without the prior written permission of Eizo Nanao Corporation. Eizo Nanao Corporation is under no obligation to hold any submitted material or information confidential unless prior arrangements are made pursuant to Eizo Nanao Corporation's receipt of said information. [. . . ] In the following cases, the signal given preference will be displayed automatically. · Once a priority is selected in the <Input Priority> function, whenever a change of signal is detected at the selected input, the monitor will switch the input to that signal. (How to give priority to the input) (1) Select <Input Priority> in the <Others> menu. (2) Select <Auto> and set BNC or D-SUB input. Saving the adjustment data The adjustment data can be saved for both signals. However, the following adjustment and setting data can be saved for each input signal (BNC/D-Sub). <Contrast>, <Fine Contrast>, <Temperature>, <Custom>, <sRGB> and <Signal Filter> 18 3. TROUBLESHOOTING If a problem persists even after applying the suggested remedies, contact an EIZO dealer. *The bracket < > indicates the function of ScreenManager Problems 1. No picture · Indicator status: Off Points to check with possible solutions Check that the power cord is correctly connected. If the problem persists, turn off the monitor power for a few minutes, then turn it back on and try again. 17) Try pressing the AUTO/FINE MODE button or control pad or turning the monitor off and then on. 17) These messages appear when the signal is not inputted correctly, even if the monitor functions properly. When the image is displayed correctly after a short time, it is not a monitor's problem. Check that the signal cable is properly connected to the PC and graphics card. Switch the signal input by pressing the BNC/D-Sub selection button on the front control panel. Use the graphics board's utility software to change the frequency setting. (Refer to the manual of the graphics board). ENGLISH · Indicator status: Green · Indicator status: Flashing Green / Yellow · Indicator status: Flashing Yellow 2. ·"No signal detected" error message appears. ·"Out of range" error message appears. Whenever an error signal message appears, the signal frequency will be displayed in red. The image vibrates on the screen. Check that the signal cable is properly connected to the PC or graphics board. The monitor may be located close to a device that is generating a magnetic field. Such devices include speakers (other than the EIZO optional i·Sound speaker), electric motors, high-voltage cables, and other monitors. [. . . ] It also demands that mercury is not present in any of the electrical or electronics components associated with the labelled unit. CFCs (freons) The relevant TCO'99 requirement states that neither CFCs nor HCFCs may be used during the manufacture and assembly of the product. CFCs break down ozone and thereby damage the ozone layer in the stratosphere, causing increased reception on earth of ultraviolet light with e. g. Lead** Lead can be found in picture tubes, display screens, solders and capacitors. [. . . ]