User manual EIZO FLEXSCAN T561

[. . . ] User's Manual FlexScan T561 Color Display Monitor SAFETY SYMBOLS This manual uses the safety symbols below. Please read them carefully. WARNING Failure to abide by the information in a WARNING may result in serious injury and can be life threatening. CAUTION Failure to abide by the information in a CAUTION may result in moderate injury and/or property or product damage. Indicates a prohibited action. Indicates to ground for safety. Copyright© 2000 by EIZO NANAO CORPORATION. No part of this manual may be reproduced, stored in a retrieval system, or transmitted, in any form or by any means, electronic, mechanical, or otherwise, without the prior written permission of Eizo Nanao Corporation. [. . . ] Every time the button is pressed, the input changes. Automatically select the input signal for screen Procedure < Others > menu / Select "Auto". < Input Signal> Auto The monitor will automatically detect the inputted signal of either the BNC or D-SUB connection for display. When turning on the monitor, the first inputted signal will be displayed. Select the active input by pressing the BNC/D-SUB selection button. Manual Adjustment data can be saved for both PCs The following adjustment and setting data can be saved for each input signal (BNC/D-Sub). < Contrast > < Fine Contrast > < Signal Filter> < Video Level > Color Mode "Standard" Color Mode "Custom" p. 15 p. 16 p. 16 p. 16 p. 17 p. 17 4. TROUBLESHOOTING If a problem persists even after applying the suggested remedies, contact an EIZO dealer. Problems 1. No picture · Indicator status: Off · Indicator status: Green · Indicator status: Flashing Green / Yellow · Indicator status: Flashing Yellow 2. Following messages appear. Points to check with possible solutions Check that the power cord is correctly connected. If the problem persists, turn off the monitor power for a few minutes, then turn it back on and try again. Check the "Contrast and Brightness" function in the ScreenManager "Main" menu. (p. 18) Try pressing the AUTO-SIZING Button or control pad or turn the monitor off and then on. (p. 18) These messages appear when the signal is not inputted correctly, even if the monitor functions properly. When the image is displayed correctly after a short time, it is not a monitor's problem. (Some PC does not output the signal soon after powering on. ) Check that the PC is turned ON. Check that the signal cable is properly connected to the PC or graphics board. Switch the signal input by pressing the BNC/D-Sub selection button on the front control panel. Use the graphics board's utility software to change the frequency setting. (Refer to the manual of the graphics board. ) · "No signal detected" error message appears. · "Out of range" error message appears. Whenever an error signal message appears, the signal frequency will be displayed in red. The image vibrates on the screen. Points to check with possible solutions Check that the signal cable is properly connected to the PC or graphics board. The monitor may be located close to a device that is generating a magnetic field. Such devices include speakers (other than the EIZO optional i·Sound speaker), electric motors, high-voltage cables, and other monitors. It may be solved by turning off or moving the interfering device, or by relocating the monitor. [. . . ] CFCs break down ozone and thereby damage the ozone layer in the stratosphere, causing increased reception on earth of ultraviolet light with e. g. Lead** Lead can be found in picture tubes, display screens, solders and capacitors. Lead damages the nervous system and in higher doses, causes lead poisoning. The relevant TCO'99 requirement permits the inclusion of lead since no replacement has yet been developed. * Bio-accumulative is defined as substances which accumulate within living organisms. [. . . ]