User manual EIZO FLEXSCAN L465

[. . . ] User's Manual Color LCD Monitor English SAFETY SYMBOLS This manual uses the safety symbols below. Please read them carefully. WARNING Failure to abide by the information in a WARNING may result in serious injury and can be life threatening. CAUTION Failure to abide by the information in a CAUTION may result in moderate injury and/or property or product damage. Indicates a prohibited action. Indicates to ground for safety. Copyright© 2001 by EIZO NANAO CORPORATION. No part of this manual may be reproduced, stored in a retrieval system, or transmitted, in any form or by any means, electronic, mechanical, or otherwise, without the prior written permission of Eizo Nanao Corporation. [. . . ] [Procedure 2] Pressing Auto adjustment button while displaying the contrast/brightness adjustment screen (appeared by pressing the control buttons directly) adjusts the range automatically. (Contrast and Brightness will not be adjusted. ) 5. To smooth the blurred texts of the enlarged screen of the lower resolutions. Switch the <Smoothing> setting. <Smoothing> is clear-cut the letters or lines. Select <Smoothing> in the screen menu and switch the setting to "Off". NOTE · The "Smoothing" is disabled in the resolution 1280 x 1024. · Since the displayed image is enlarged, the blurred texts may not be necessarily lost completely. 22 4. Use the <Contrast> adjustment. This controls the brightness for the each color (red, blue and green) at the same time. Select <Contrast/Brightness> and adjust by using the right and left buttons. NOTE · Percentage except 100 % may cause undisplayable color tone. · During selecting the <sRGB> of <ColorManagement>, contrast cannot be adjusted. 7. To Set the Brightness of the screen. Use the <Contrast> adjustment. The brightness of the entire screen is controlled by changing the brightness of the backlight. Select <Contrast/Brightness> in the screen menu and adjust by using the up and down buttons. NOTE · Directly pressing the up and down buttons also adjusts the contrast and brightness. Press the "Enter" button to save and exit the settings after the adjustment. 4. Color Adjustment The <ColorManagement> menu in the ScreenManager enables to change the color of the screen. By using the <Color Mode>, the adjustment mode can be selected from <Custom mode> (to adjust the color settings according to your preference) and <sRGB> mode. In the analog input, perform the "Range Adjustment" (p. 22) before making the color adjustments. NOTE · Allow the LCD monitor to stabilize for at least 20 minutes before making image adjustments. (Allow the monitor to warm up for at least 20 minutes before making adjustments. ) · Performing the <Reset> of the <ColorManagement> menu returns the color settings to the default settings (Except <Range Adjustment> settings). · The values shown in percentages represent the current level within the specific adjustment. (To create an uniform white or black screen, the percentages for each will probably not be the same. ) <Custom> mode: To adjust the color settings according to your preference To set the color temperature (p. 34) Set the <Temperature>. The <Temperature> can be set from 4, 000 K to 10, 000 K, in 500 K increments (including 9, 300 K). NOTE · The values shown in the Kelvin are available only as a reference tool. · Setting the temperature under 4, 000 K or over 10, 000 K invalidates the color temperature setting. [. . . ] The relevant TCO'99 requirement states that batteries may not contain any mercury. It also demands that mercury is not present in any of the electrical or electronics components associated with the labelled unit. CFCs (freons) The relevant TCO'99 requirement states that neither CFCs nor HCFCs may be used during the manufacture and assembly of the product. CFCs break down ozone and thereby damage the ozone layer in the stratosphere, causing increased reception on earth of ultraviolet light with e. g. [. . . ]