User manual EIZO DURAVISION DV1908-001

[. . . ] at the press of a button , the monitor performs these alignments automatically. The DV1908 is equipped with a 19 active TFT display module with a physical resolution of 1280 x 1024 pixels. The function "up / down scaling" makes it possible to show pictures with a lower or a higher resolution on the full screen. The integrated VESA DPMS power management system allows significant reduction in power consumption compared with the "normal" operation, if the computer disables the synchronization signal. [. . . ] If devices are removed or added to the system, the unit must always be switched off and the power supply cable unplugged. ⷠSensitive devices should always be held at their edge to avoid the touch of tracks and contact pins. Compare the received components with the delivery note · All unpacked delivered components should be checked for completeness and possible transport damage. If any deficiencies are found please contact the service department given on the delivery note, they need the delivery note number, serial number and a description of the deficiency. In order to guarantee safe and interference-free operation the following points should be kept in mind during installation. Thermal Considerations In the ambient of the monitor the air should circulate to get optimum operating temperature for the DV1908. Furthermore the air convection must be guaranteed this is very important for the rear of the unit. Please bear in mind that increased temperatures can lead to defects and to a significant reduction in the lifetime of the monitor. EMC Considerations This LCD monitor is a piece of equipment designed for building into an industrial system. The operator of the entire plant is responsible for maintaining electromagnetic compatibility according to EMC laws. Safety Considerations All voltage and signal connections must adhere to legal requirements. Ergonomics The screen should be easily viewable from all sides without reflections. Before connecting the DV1908 to the power supply, the signal should be plugged in properly and the screws have been tightened. The monitor can be connected directly to the power supply (check polarity of voltage connections). TMDS-Data 1 TMDS-Data 1 + TMDS-Data Shield 1 (GND) +5 V Power (In) GND Hot Plug Detect TMDS-Data 0 TMDS-Data 0 + TMDS-Data Shield 0 (GND) TMDS-CLK Shield (GND) TMDS-CLK + TMDS-CLK Analog red Analog green Analog blue Analog H-Sync. 3 Signal Video input RED Video input GREEN Video input BLUE Not used Not used GND (RED) GND (GREEN) GND (BLUE) Not used GND Not used Not used H-Sync. The TFT monitor has an integrated AC power supply unit which provides all voltages which are used for operating the unit. Before connecting the DV1908 to the power supply, take care that the signal is plugged in properly and that the screws have been tightened. The monitor can be connected directly to the power supply (check voltage level). if a valid signal is connected , the image will appear on the screen immediately. There are some possible reasons if the unit does not show a picture when it is switched on: · All operating controls can be accessed from the rear of the unit. These controls are used for navigating and changing values in the OSD menu. [. . . ] RGB analog) mode number (internal mode number of the timing list) Image resolution of the input signal H- and V- frequency Red ­ green ­ blue - black red ­ green - blue - black on - off Inhibits new auto-alignment during display of a video signal when short-term noise is present on synchronous signals. The settings of this timing will always be used, even if variations in H- and V-frequency will occur by noise. The settings of this timing will always be used, even if variations in H- and V-frequency will occur by noise. OSD language Adjustment of the internal A/D converter, follow the menu Memorize (freeze) of the monitor content Reset of values like brightness, contrast, . [. . . ]