User manual EINHELL SB 701/1

[. . . ] Keep your tools sharp and clean so that you can work efficiently and safely. follow the maintenance regulations and the instructions for changing tools. Wear suitable work clothes and personal protection equipment Loose clothing is not suitable, as it can be caught by moving parts, causing you to become entangled. As a general rule, jewelry should not be worn when working with machine tools. [. . . ] Align the head so that it is horizontal to the base plate and fasten it in position with the screws (35). B Before you mount the drill chuck with the MK shank, check that both parts are clean. Insert the taper mandrel in the taper of the drill chuck with a powerful jolt. Important: All bare parts are greased in order to protect them from corrosion. Before mounting the drill chuck (10) onto the spindle (11), both parts must be completely degreased using an environmentally friendly solvent. 4/5) Before you use the drill for the first time it must be permanently fixed in position. Important: The fixing screws may only be tightened Maximum workpiece size Workpieces (max. 20 x 20 cm) may only be processed if they can be clamped securely on the drill table or in the vise. Now, please read and follow all steps and procedures included in the operating instructions. Push the transparent cover (23) into the groove of the red mounting frame (24) and fasten it again with the recessed head screws (21). The height of the cover (23) is infinitely adjustable and can be locked using the two thumb screws (22). Prior to starting Ensure that the voltage of the mains supply complies with the specifications on the rating plate. Connect the machine only to a socket with the properly installed earthing contact. The table drill is equipped with a no-volt trip that is designed to protect the operator from an undesired restart following a drop in voltage. 1/2) Make sure that the power plug is removed from the socket-outlet before changing tools. Only cylindrical tools with the stipulated maximum shaft diameter may be clamped in the scroll chuck (10). Do not use tools whose shaft is damaged or which are deformed or flawed in any other way. Use only accessories and attachments that are specified in the operating instructions or have been approved by the manufacturer. T insert a drill bit, flip up the chip guard (13), insert the drill bit, then tighten down the drill chuck using the supplied chuck key. Doing so will cause the chuck key to rapidly shoot out, which could cause injury. Handling the quick-change drill chuck (SB 1020/1 and SB 1625/1) The pillar drills SB 1020/1 and SB 1625/1 are equipped with a quick-change drill chuck. This enables tools to be changed without the need for an additional chuck key. [. . . ] There must be enough distance between the upper edge of the workpiece and the tip of the drill bit. Countersinking and center-drilling With this table drill, you can also countersink and center-drill. Please observe that countersinking should be performed at the lowest speed, while a high speed is required for center-drilling. Pull out the mains plug before doing any cleaning and maintenance work on the machine. [. . . ]