User manual EINHELL RT-PG 2500

[. . . ] Altitude above sea level 1000 m, relative humidity: 90 % (non-condensing) The generator is driven by a combustion engine, which produces heat in the area of the exhaust (on the opposite side of the sockets) and the exhaust outlet. You should therefore keep clear of these surfaces because of risk of skin burns. The values quoted in the technical data for sound power level (LWA) and sound pressure level (LpA) are emission values and not necessarily reliable workplace values. As there is a correlation between emission and immission levels, the values are not a reliable basis for deciding on any additional precautions which may be needed. [. . . ] 3 Connecting to earth The housing is allowed to be connected to earth in order to discharge static electricity. To do this, connect one end of a cable to the earth connection on the generator (Fig. 3/4) and the other end to an external earth (for example an earthing rod). Important: These sockets may be loaded continuously (S1) with 2000W and temporarily (S2) for a maximum of 5 minutes with 2200W. Do not connect the generator to the domestic power network as this may result in damage to the generator itself or to other electrical appliances in your home. ) may have a higher level of power consumption when used in difficult conditions. 3 Switching off the engine Before you switch off the generator, allow it to run briefly with no consumers so that it can "cool down" Move the ON/OFF switch (10) to position "OFF" with the key. If this happens, reduce the electric power you are taking from the generator or remove any defective connected appliances. Defective overload cut-outs must be replaced only by overload cut-outs of identical design and with the same performance data. If repairs are necessary, please contact your customer service center. Check the fuel level and top it up if necessary Make sure that the generator has sufficient ventilation Make sure that the ignition cable is secured to the spark plug Inspect the immediate vicinity of the generator Disconnect any electrical equipment which may already be connected to the generator 6. 1 Starting the engine Open the petrol cock (13) by turning it down Move the ON/OFF switch (10) to position "ON" with the key. When starting with the reserve starter, the motor may recoil suddenly as it starts up, resulting in hand injuries. 2 Connecting consumers to the generator Connect the equipment you want to use to the 230 V~sockets (3) Switch off the motor and pull the spark plug boot from the spark plug before doing any cleaning and maintenance work on the equipment. Important: Switch off the machine immediately and contact your service station: In the event of unusual vibrations or noise If the engine appears to be overloaded or misfires 7. 1 Cleaning Keep all safety devices, air vents and the motor housing free of dirt and dust as far as possible. Wipe the equipment with a clean cloth or blow it with compressed air at low pressure. We recommend that you clean the device immediately each time you have finished using it. Do not use cleaning agents or solvents; these could attack the plastic parts of the equipment. 2 Air filter In this connection, please also read the service information. 6/C) Do not use abrasive cleaning agents or petrol to clean the elements. In cases of stubborn dirt first clean with soapy water, then rinse with clear water and airdry. [. . . ] In the unlikely event that your device develops a fault, please contact our service department at the address shown on this guarantee card. Of course, if you would prefer to call us then we are also happy to offer our assistance under the service number printed below. Please note the following terms under which guarantee claims can be made: 1. Please enclose either the original or a copy of your sales receipt or another dated proof of purchase. [. . . ]