User manual EINHELL RT-ID 75

[. . . ] Keep all safety regulations and instructions in a safe place for future use. LpA sound pressure level KpA uncertainty LWA sound power level KWA uncertainty 98 dB(A) 3 dB 109 dB(A) 3 dB Total vibration values (vector sum of three directions) determined in accordance with EN 60745. The drill is designed for drilling holes into wood, iron, non-ferrous metals and rock using the appropriate bits. The user / operator and not the manufacturer will be liable for any damage or injuries of any kind caused as a result of this. [. . . ] Benefits: The drill bit is easier to control when starting the hole and will not slide away. 11/Item 6) The speed setting ring (6) enables you to define the maximum speed. The ON/OFF switch (5) can only be pressed to the defined maximum speed setting. Switch the direction of the hammer drill using the clockwise/counter-clockwise switch (7): Direction Switch position Clockwise (forwards and drill) Pushed in to the right Counter-clockwise (reverse) Pushed in to the left 6 Drilling with the dust extraction system (9) Use the dust extraction system only for drilling into concrete, bricks and masonry since wood or plastic chips may block the extraction system. Do not drill into metallic materials since hot metal chips can damage the dust extraction system. Harmful dust must not be extracted using the dust extraction system (9). Tip: To prevent the wall being soiled, you can mask the area around the transparent extraction opening with masking tape. Before you use the masking tape, test whether the tape can be removed easily from the wall again in a place that it not easily visible. Switch on the vacuum cleaner and place the transparent cover on the front of the dust extraction system (9) over the drilling point so that the drill bit is in front of the mark. Ensure that the transparent cover is in contact with the workpiece or wall. The dust extraction system (9) must be cleaned after at least every 15 holes. Clean the dust extraction system (9) and the interior of the additional handle (8) by carefully tapping them or blowing them through with low pressure compressed air. if the extraction performance is poor , check the dust extraction system (9) for possible blockages or dirt. The transparent cover is enclosed in a protective ring to prevent it from suffering damage. This protective ring should be replaced as soon as it is damaged or worn. Always use carbide drill bits and a high speed setting for drilling into masonry and concrete. Always use HSS drill bits (HSS = high speed steel) and a low speed setting for drilling steel. We recommend that you lubricate the hole with a suitable cutting fluid to prevent unnecessary drill bit wear. 4 Starting holes If you wish to drill a deep hole in a hard material (such as steel), we recommend that you start the hole with a smaller drill bit. Switch the drill / hammer drill selector switch (3) to position B (hammer drill) as soon as the drill bit has passed through the tiles. If the power cable for this equipment is damaged, it must be replaced by the manufacturer or its aftersales service or similarly trained personnel to avoid danger. Always pull out the mains power plug before starting any cleaning work. [. . . ] Dear Customer, All of our products undergo strict quality checks to ensure that they reach you in perfect condition. In the unlikely event that your device develops a fault, please contact our service department at the address shown on this guarantee card. Of course, if you would prefer to call us then we are also happy to offer our assistance under the service number printed below. Please note the following terms under which guarantee claims can be made: 1. [. . . ]