User manual EINHELL RT-HP 1855 TR

[. . . ] Any errors made in following the safety regulations and instructions may result in an electric shock, fire and/or serious injury. Keep all safety regulations and instructions in a safe place for future use. 1 Correctly using the device b The high-pressure cleaner must be set on a level, stable surface. B It is recommended that you maintain the correct operating position every time you use the machine by placing one hand on the pistol and the other on the lance. [. . . ] secure the high-pressure hose in the holder (a) provided for this purpose as shown in Figure 14. Now wind up the hose evenly onto the hose reel using the crank handle (2). Before using the pressure cleaner, make sure that the high-pressure hose is completely unwound. If the problem repeats itself, please contact a customer service center. 3 Ordering replacement parts: Please quote the following data when ordering replacement parts: Type of machine Article number of the machine Identification number of the machine Replacement part number of the part required For our latest prices and information please go to www. Always pull out the mains power plug before starting any cleaning work. 1 Cleaning Keep all safety devices, air vents and the motor housing free of dirt and dust as far as possible. Wipe the equipment with a clean cloth or blow it with compressed air at low pressure. We recommend that you clean the device immediately each time you have finished using it. Do not use cleaning agents or solvents; these could attack the plastic parts of the equipment. 16) Periodically check the intake filter in order to prevent clogging, which could jeopardize operation of the pump. To do this, unscrew the connection coupling for the water inlet hose from the device and clean the exposed inlet sieve by placing it under running water. 2 Long periods of nonuse (electric pump) If the machine is going to be stored for longer periods of time (i. Over 3 months) in a room where frost could develop, it is recommended that the machine be filled with an antifreeze solution (similar to the antifreeze solutions used for vehicles). When the device is not used for an extended period of time, lime deposits begin to form in the electric pump, which in turn can lead to starting difficulties. The unit is supplied in packaging to prevent its being damaged in transit. This packaging is raw material and can therefore be reused or can be returned to the raw material system. The unit and its accessories are made of various types of material, such as metal and plastic. Remedy - Check the fuse, power cable and power plug and have them replaced by qualified personnel if necessary. - Use extension cables with larger cross sections and/or use shorter extension cables. - Cross section of the extension cable not large enough and/or the extension cable is too long. The motor starts but there is no build up of pressure - The water intake filter is clogged. [. . . ] no guarantee claims will be accepted after the end of the guarantee period. The original guarantee period remains applicable to the device even if repairs are carried out or parts are replaced. In such cases, the work performed or parts fitted will not result in an extension of the guarantee period, and no new guarantee will become active for the work performed or parts fitted. In order to assert your guarantee claim, please send your defective device postage-free to the address shown below. [. . . ]