User manual EINHELL RG-WW 6536

[. . . ] The manufacturer's warranty does not cover damage caused to the equipment as a result of running it dry. Any errors made in following the safety regulations and instructions may result in an electric shock, fire and/or serious injury. Keep all safety regulations and instructions in a safe place for future use. In stagnant water bodies, garden ponds, swimming ponds and their surrounding areas the unit may only be used with an earth-leakage circuit breaker with an actuating rated current of up to 30 mA (according to VDE 0100 Part 702 and 738). [. . . ] ) in the pressure line so that the air can escape without obstruction. The pump is switched off automatically by the thermostat if overheating occurs and is switched on again automatically after cooling. Mains connection 230V ~ 50 Hz Power rating 650 W Pumping rate without non-return valve: 3750 l/h Pumping rate with non-return valve: 3450 l/h Max. Unscrew the coarse filter screw (7) and remove the coarse filter (9) together with the non-return valve (10) as shown in Figure 2. Now you can fill the pump housing with water via the coarse filter screw (7). Switch on the equipment with the power switch (3) - water can be suctioned in for up to 5 minutes (maximum suction height). The equipment will shut down when the cut-out pressure of 3 bar is reached. After a loss of pressure due to water consumption the equipment will cut in again automatically (cutin pressure approx. After finishing the work, switch off the equipment with the power switch (3). Inside the pressure tank is an expandable water sack and an air compartment whose maximum pressure should lie at approx. Pumping water into the water sack causes the sack to expand so that the pressure in the air compartment rises to switch-off level. To do so, unscrew the plastic lid from the tank and top up the pressure to the correct level using a tyre pump with meter at the valve. Important: Be sure to completely empty the water bag first using the water drain screw (5). Replacing the mains cable: Important: Disconnect the equipment from the power supply! a defective mains cable may only be replaced by a qualified electrician. There are no parts inside the equipment which require additional maintenance. Remove the coarse filter screw (7) and coarse filter (9) together with the non-return valve (10) (Figure 2). Do not use abrasive cleaning agents or petrol to clean the coarse filter and the non-return valve. Clean the coarse filter and the non-return valve by tapping them on a flat surface. In cases of stubborn dirt, first clean with soapy water, then rinse with clear water and air-dry. 3 Storage If the pump is not going to be used for a long time or has to be removed for the winter months, rinse it out with water, empty it completely and allow it to dry. The equipment must be completely drained before it is subjected to frost. [. . . ] In the unlikely event that your device develops a fault, please contact our service department at the address shown on this guarantee card. Of course, if you would prefer to call us then we are also happy to offer our assistance under the service number printed below. Please note the following terms under which guarantee claims can be made: 1. These guarantee terms cover additional guarantee rights and do not affect your statutory warranty rights. [. . . ]