User manual EINHELL RG-SP 750 LL

[. . . ] This equipment is not designed to be used by people (including children) with limited physical, sensory or mental capacities or those with no experience and/or knowledge unless they are supervised by a person who is responsible for their safety or they have received instructions from such a person in how to use the equipment safely. Children must always be supervised in order to ensure that they do not play with the equipment. Before you put the equipment into operation, arrange for a specialist to check that the - earthing - protective multiple earthing - residual-current operated circuit-breaker circuit comply with the safety regulations of the power supply company and work correctly. The electrical plug-in connections must be protected from wet conditions. [. . . ] This bridges the integrated floating switch so that the equipment runs continuously. Please note: The depth of water must be at least 15 mm before the equipment can be run in manual mode!Before putting the equipment into operation 2) Secure the carry handle (1) with the fastening nut (3) (Fig. 2 Installation The equipment can be installed either: Stationary with rigid tubing or Stationary with a flexible hose line Note!When installing, never hang the equipment by the discharge line or by the power cable. The equipment must be hung up with the provided carry handle or it must rest on the bottom of the shaft. To ensure that the equipment works properly, the bottom of the shaft always must be free of sludge and other accumulations of dirt. If the water level is too low, the sludge in the shaft can quickly dry out and hinder the equipment from starting. It is necessary therefore to check the equipment regularly (carry out trial startups). Note: The pump shaft should measure at least 10 If the power cable for this equipment is damaged, it must be replaced by the manufacturer or its aftersales service or similarly trained personnel to avoid danger. The unit is supplied in packaging to prevent its being damaged in transit. This packaging is raw material and can therefore be reused or can be returned to the raw material system. The unit and its accessories are made of various types of material, such as metal and plastic. For mobile applications, the equipment should be cleaned with clear water after every usage. For stationary installation, it is recommended that you check the floating switch for proper functioning every three months. Use a water jet to remove any lint or fibrous particles that may have become trapped in the housing. Remove sludge from the shaft bottom and clean the shaft walls every 3 months. 1 Cleaning the paddle wheel If a lot of deposits collect in the housing, the bottom part of the equipment must be dismantled as follows: 1. 2 Maintenance There are no parts inside the equipment which require additional maintenance. 3 Ordering replacement parts: Please quote the following data when ordering replacement parts: Type of machine Article number of the machine Identification number of the machine Replacement part number of the part required For our latest prices and information please go to www. Faults The equipment does not start Cause - Power supply not connected - Floating switch does trigger The equipment does not pump - Intake sieve clogged - Discharge hose kinked The equipment does not cut out - Floating switch cannot sink Remedy - Check power supply - Raise position of floating switch - Clean intake sieve with water jet - Unkink the hose - Place equipment correctly on shaft bottom - Clean intake sieve - Clean equipment and replace wear parts The equipment switches off after briefly running - Motor circuit-breaker switches the equipment off due to excessive water contamination - Water temperature too high; motor circuit-breaker switches the equipment off - Unplug power plug and clean equipment and shaft K t p erklärt folgende Konformität gemäß EU-Richtlinie und Normen für Artikel declares conformity with the EU Directive and standards marked below for the article déclare la conformité suivante selon la directive CE et les normes concernant larticle verklaart de volgende conformiteit in overeenstemming met de EU-richtlijn en normen voor het artikel declara la siguiente conformidad a tenor de la directiva y normas de la UE para el artículo declara a seguinte conformidade de acordo com a directiva CE e normas para o artigo förklarar följande överensstämmelse enl. T For EU countries only Never place any electric tools in your household refuse. [. . . ] The original guarantee period remains applicable to the device even if repairs are carried out or parts are replaced. In such cases, the work performed or parts fitted will not result in an extension of the guarantee period, and no new guarantee will become active for the work performed or parts fitted. In order to assert your guarantee claim, please send your defective device postage-free to the address shown below. Please enclose either the original or a copy of your sales receipt or another dated proof of purchase. [. . . ]