User manual EINHELL RG-DP 1035 N

[. . . ] This equipment is not designed to be used by people (including children) with limited physical, sensory or mental capacities or those with no experience and/or knowledge unless they are supervised by a person who is responsible for their safety or they have received instructions from such a person in how to use the equipment safely. Children must always be supervised in order to ensure that they do not play with the equipment. Before you put the equipment into operation, arrange for a specialist to check that the - earthing - protective multiple earthing - residual-current operated circuit-breaker circuit comply with the safety regulations of the power supply company and work correctly. The electrical plug-in connections must be protected from wet conditions. [. . . ] 1 Installation The equipment can be installed either: Stationary with rigid tubing or Stationary with a flexible hose line Note: The maximum pumping rate is possible only with the largest possible line diameter; if smaller hoses or tubes are connected, the pumping rate will be reduced. 2) to the connection actually used in order not to reduce the pumping rate unnecessarily. Flexible hoses must be fastened to the universal hose connection with a hose clip (not included in the scope of supply). When installing, never hang the equipment by the discharge line or by the power cable. The equipment must be hung up with the provided carry handle or it must rest on the bottom of the shaft. To ensure that the equipment works properly, the bottom of the shaft always must be free of sludge and other accumulations of dirt. If the water level is too low, the sludge in the shaft can quickly dry out and hinder the You can put the equipment into operation after you have thoroughly read the installation and operating instructions. Pay attention to the following points: Make sure that the equipment is set up securely. Make sure that no moisture or water can ever reach the power connection. Setting the ON/OFF switching point: The ON/OFF switching point can be infinitely adjusted with the height adjustment facility. Check the following points before putting the equipment into operation: The floating switch must be fitted so that the switching point height: ON and the switch point height: OFF can be reached easily and with little force. Check this by placing the equipment in a container filled with water and carefully raising and lowering the floating switch with your hand. Make sure that the distance between the floating switch head and the cable holder is not too small. If the distance is too small, there is no guarantee that the equipment will work correctly. When adjusting the floating switch, make sure that the floating switch does not touch the bottom before the equipment is switched off. manual operation: Mount the floating switch as illustrated in Figure 4. The equipment must only be used in this mode under supervision to prevent it operating without water. The equipment must be switched off (pull the mains plug) as soon as no more water is emitted from the discharge pipe. 1 Cleaning the paddle wheel If a lot of deposits collect in the housing, the bottom part of the equipment must be dismantled as follows: 1. 2 Maintenance There are no parts inside the equipment which require additional maintenance. 3 Ordering replacement parts: Please quote the following data when ordering replacement parts: Type of machine Article number of the machine Identification number of the machine Replacement part number of the part required For our latest prices and information please go to www. If the power cable for this equipment is damaged, it must be replaced by the manufacturer or its aftersales service or similarly trained personnel to avoid danger. [. . . ] In the unlikely event that your device develops a fault, please contact our service department at the address shown on this guarantee card. Of course, if you would prefer to call us then we are also happy to offer our assistance under the service number printed below. Please note the following terms under which guarantee claims can be made: 1. These guarantee terms cover additional guarantee rights and do not affect your statutory warranty rights. [. . . ]