User manual EINHELL REB 1300 F

[. . . ] Power supply The machine can be connected to any light socketoutlet (with 230 Volt alternating current). However, the socket outlet must have an earthing contact protected by a 16 A circuit breaker. Power cable for the device Please only use power cables that are not damaged. The total length of the power cable should not exceed 50 meters; going beyond this distance will reduce the power output of the electric motor. [. . . ] Insodoing, the aeration swaths should always overlap each other by a few centimeters in order to avoid bare strips. Switch off the motor promptly when you arrive at the end of the area you wished to hoe. The motor must be switched off when you raise the machine (for example to change direction). Deposits make it more difficult to start the machine and decrease the working depth. The machine must be switched off and the mains cable disconnected before you make any checks on the hoe blades. The hoe blades will continue to rotate for a few seconds after the motor is switched off. In the event that the rotating hoe blade strikes an object, immediately switch off the machine and wait for the hoe blades to come to a complete stop. 7/Item A) and secure the power cable with the strain-relief clamp (Fig 7/Item 5). Repeat this process several times so that you are sure that your machine functions properly. Before you perform any repair or maintenance work on the machine, ensure that the hoe blades are not rotating and that the power Lay the power cable on the ground in front of the outlet in a figure 8. Work away from the outlet or cable and ensure that the power cable always trails in the hoed soil which will prevent the hoe blades from traveling over the cable. Please quote the following data when ordering replacement parts: Type of machine Article number of the machine Identification number of the machine Replacement part number of the part required For our latest prices and information please go to www. Maintenance and cleaning work on the machine as well as removal of the safety devices may only be performed when the motor is switched off and the power cable has been pulled. Worn out or damaged hoe blades should only be replaced by an authorized professional (see address on warranty certificate). Do not clean the tool with running water - and particularly not with a pressure hose. ) are always tightened so that the machine can be safely operated at all times. All the metal parts should be cleaned and then oil to ensure that they provide a long life. For best results, clean the plastic parts of the machine with a brush or rag. At the end of the season, perform a general inspection of the machine and remove any deposits which may have accumulated. At the start of each season, ensure that you check the condition of the machine. If repairs are necessary, please contact one of our customer service centers (see address on warranty certificate). Voltage Power input Working width Hoe diameter Idle speed Number of blades LPA noise level LWA peak noise level Vibration at the handlebars ahv 230V ~ 50Hz 1300 W 26 cm 23 cm 110 rpm 4 pieces 76 dB(A) 93 dB(A) 2. [. . . ] The following are also excluded from our guarantee: compensation for transport damage, damage caused by failure to comply with the installation/assembly instructions or damage caused by unprofessional installation, failure to comply with the operating instructions (e. Connection to the wrong mains voltage or current type), misuse or inappropriate use (such as overloading of the device or use of non-approved tools or accessories), failure to comply with the maintenance and safety regulations, ingress of foreign bodies into the device (e. Damage caused by the device being dropped) and normal wear resulting from proper operation of the device. The guarantee is rendered null and void if any attempt is made to tamper with the device. [. . . ]