User manual EINHELL KSGZ300-1

[. . . ] it is also imperative to observe the accident prevention regulations in force in your area. The same applies for the general rules of occupational health and safety. The manufacturer shall not be liable for any changes made to the machine nor for any damage resulting 12 Always pull the plug out of the power socket before adjusting or servicing the machine. Before you use the machine for the first time, check that the voltage marked on the rating plate is the same as your mains voltage. [. . . ] Electric installation work, repairs and maintenance are to be carried out only by specialists. All guards and safety devices have to be refitted immediately after completion of any repairs or maintenance. It is imperative to observe the manufacturer's safety, operating and maintenance instructions as well as the dimensions quoted in the technical data. It is imperative to observe the accident prevention regulations in force in your area as well as all other generally recognized rules of safety. (VBG7j) Switch on the dust extraction system each time you use the machine. The machine may be used in closed rooms only in conjunction with a suitable vacuum extraction system. The circular cross-cut must be connected to a 230 V socket-outlet with a minimum 10 A fuse. Never use the cable for any purpose other than that for which it is intended!Before you carry on using the tool it is imperative to check that its safety devices and any slightly damaged parts are working properly and in the way intended. Check that the moving parts work properly and do not jam or whether any of the parts are damaged. Unless otherwise stated in these instructions, damaged safety devices and parts must be repaired or replaced by experts in an approved specialist workshop. Repairs are to be carried out only by qualified electricians using original replacement parts. With this information the user should at least be able to make a better assessment of the dangers and risks involved. Asynchronous motor Output Operating mode Idle speed n0 Carbide-tipped saw blade Number of teeth Tilting range Mitre cuts 230 V~ 50 Hz 1800 W S1 4600 min-1 ø 250 x ø 30 x 3. Wear a breathing mask Noise emission values The saw's noise is measured in accordance with DIN EN ISO 3744; 11/95, E Din EN 31201; 6/93, ISO 7960 Annex A; 2/95. In this case, noise protection measures need to be introduced for the user (ear-muffs). Idle speed Sound pressure level LPA Sound power level LWA 89, 2 dB(A) 102, 2 dB(A) Before putting the machine into operation The machine must be firmly mounted in working position, e. All the covers and safety devices have to be properly fitted before the machine is switched on. When working with wood that has been processed before, watch out for foreign bodies such as nails or screws etc. Before you actuate the On/Off switch, make sure that the saw blade is correctly fitted and that the machine's moving parts run smoothly. Before you connect the machine to the power supply, make sure the data on the rating plate is the same as that for your mains. , , The quoted values are emission values and not necessarily reliable workplace values. [. . . ] Re-tighten the locking nut (13) and make the cut as described in Section 7. Undo the locking nut (13) and, holding the handle (2), tilt the machine head (4) to the left by 45° Place the 45° stop angle (b) between the saw blade (5) and the rotary table (8). The product described in these instructions comes with a 2 year warranty covering defects. This 2-year warranty period begins with the passing of risk or when the customer receives the product. [. . . ]