User manual EINHELL BT-LS 65 U

[. . . ] Safety information Please refer to the booklet included in delivery for the safety instructions. Any errors made in following the safety regulations and instructions may result in an electric shock, fire and/or serious injury. Keep all safety regulations and instructions in a safe place for future use. 5. Technical data Voltage: 230 V 50 Hz 1500 W S2 20 min 2950 rpm B IP 54 5. 5 t 390 mm 0. 035 m/sec 50 - 250 mm 520 mm 3. 2 l 48 kg 65 dB(A) 2. [. . . ] If the trunk fails to split immediately, never attempt to force it to split by maintaining the pressure for more than a few seconds. It is far more advisable to try and reposition the trunk on the splitter or to remove the trunk altogether and place it to one side. By doing this you will make sure that you have a safe area in which to work because you will keep it clear of obstacles and prevent any risk of tripping over or of the power cable becoming damaged. Insert a triangular shaped wooden wedge under the trunk and then start the trunk pusher to press the wedge under the stuck trunk. Repeat this process with larger and larger wedges until the stuck trunk is released. Never hammer against the stuck trunk or place your hands anywhere near the trunk when trying to release it. NEVER ASK ANYONE ELSE TO HELP WHEN TRYING TO RELEASE A TRUNK WHICH HAS BECOME STUCK. NEVER ATTEMPT TO RELEASE THE TRUNK BY HITTING IT WITH A TOOL. Anleitung_BT_LS_65_U_SPK1:_ 12. 11. 2008 11:12 Uhr Seite 15 GB 7. Cleaning, maintenance and ordering of spare parts Always pull out the mains power plug before starting any cleaning work. 7. 1 Cleaning Keep all safety devices, air vents and the motor housing free of dirt and dust as far as possible. Wipe the equipment with a clean cloth or blow it with compressed air at low pressure. We recommend that you clean the device immediately each time you have finished using it. Do not use cleaning agents or solvents; these could attack the plastic parts of the equipment. 7. 2 Maintenance There are no parts inside the equipment which require additional maintenance. Once it has been in use for some time, or as and when necessary, you should sharpen the wedge with a fine-toothed file and carefully remove any burrs or flat areas on the edge. Always disconnect the device from the power supply before starting any maintenance work!13-16) The hydraulic oil should be changed after every 300 hours of operation. The oil seal (F) is made of rubber and is very easily damaged if the oil screw is tightened too strongly. Place a container with a capacity for at least 4 liters of oil beneath the wood splitter. Tilt the wood splitter so that the drainage opening (G) faces upwards. Fill the machine with the amount of hydraulic oil required with the help of a clean funnel. (Make sure that you only use clean, high-quality hydraulic oil which is specifically intended for this purpose. ) 5. [. . . ] Recycling alternative to the demand to return electrical devices: As an alternative to returning the electrical device, the owner is obliged to cooperate in ensuring that the device is properly recycled if ownership is relinquished. This can also be done by handing over the used device to a returns center, which will dispose of it in accordance with national commercial and industrial waste management legislation. This does not apply to the accessories and auxiliary equipment without any electrical components which are included with the used device. p Uniquement pour les pays de l'Union Européenne Ne jetez pas les outils électriques dans les ordures ménagères. [. . . ]