User manual EINHELL BT-ID 650 E

[. . . ] Keep this manual in a safe place, so that the information is available at all times. If you give the equipment to any other person, give them these operating instructions as well. We accept no liability for damage or accidents which arise due to non-observance of these instructions and the safety information. Please note that our equipment has not been designed for use in commercial, trade or industrial applications. [. . . ] Switch the direction of the hammer drill using the clockwise/counter-clockwise switch (7): Direction Clockwise (forwards and drill) Counter-clockwise (reverse) Switch position R L 6. 6. 3 Inserting/Removing screws Switch the Drill/Hammer drill selector switch (3) to position A (drill). Use a low speed setting 6. 6. 4 Starting holes If you wish to drill a deep hole in a hard material (such as steel), we recommend that you start the hole with a smaller drill bit. 6. 6. 5 Drilling tiles To start the hole, switch the drill / hammer drill selector switch (3) to position A (drill). Switch the drill / hammer drill selector switch (3) to position B (hammer drill) as soon as the drill bit has passed through the tiles. 7. Replacing the power cable If the power cable for this equipment is damaged, it must be replaced by the manufacturer or its aftersales service or similarly trained personnel to avoid danger. 6. 5 Drill / hammer drill selector switch (Fig. 7/Item 3) Change switch position only when the drill is at a standstill!(Position A) Use for: Wood, metal, plastic Hammer drill Drill / hammer drill selector switch (3) in the hammer drill position. (Position B) Use for: Concrete, rock, masonry 6. 6 Tips for working with your hammer drill 6. 6. 1 Drilling concrete and masonry Switch the Drill/Hammer drill selector switch (3) to position B (Hammer drill). Always use carbide drill bits and a high speed setting for drilling into masonry and concrete. 6. 6. 2 Drilling steel Switch the drill / hammer drill selector switch (3) to position A (drill). Always use HSS drill bits (HSS = high speed steel) and a low speed setting for drilling steel. We recommend that you lubricate the hole with a suitable cutting fluid to prevent unnecessary drill bit wear. 8. Cleaning, maintenance and ordering of spare parts Always pull out the mains power plug before starting any cleaning work. 8. 1 Cleaning Keep all safety devices, air vents and the motor housing free of dirt and dust as far as possible. Wipe the equipment with a clean cloth or blow it with compressed air at low pressure. We recommend that you clean the device immediately each time you have finished using it. Do not use cleaning agents or solvents; these could attack the plastic parts of the equipment. 8. 2 Carbon brushes In case of excessive sparking, have the carbon brushes checked only by a qualified electrician. The carbon brushes should not be rep laced by anyone but a qualified electrician. 8. 3 Maintenance There are no parts inside the equipment which require additional maintenance. 13 Anleitung BT-ID 650 E_SPK1:_ 20. 02. 2008 11:09 Uhr Seite 14 GB 8. 4 Ordering replacement parts: Please quote the following data when ordering replacement parts: Type of machine Article number of the machine Identification number of the machine Replacement part number of the part required For our latest prices and information please go to www. isc-gmbh. info 9. Disposal and recycling The unit is supplied in packaging to prevent its being damaged in transit. This packaging is raw material and can therefore be reused or can be returned to the raw material system. [. . . ] The original guarantee period remains applicable to the device even if repairs are carried out or parts are replaced. In such cases, the work performed or parts fitted will not result in an extension of the guarantee period, and no new guarantee will become active for the work performed or parts fitted. In order to assert your guarantee claim, please send your defective device postage-free to the address shown below. Please enclose either the original or a copy of your sales receipt or another dated proof of purchase. [. . . ]