User manual EINHELL BT-CD 18 I

[. . . ] We accept no liability for damage or accidents which arise due to non-observance of these instructions and the safety information. machine is used in commercial, trade or industrial businesses or for equivalent purposes. 4. Technical data Voltage supply Idling speed: Torque settings: Forward and reverse rotation Chuck clamping width Battery charging voltage Battery charging current Mains voltage for charger Charging time: Battery type: Weight 18 V d. c. Safety information Please refer to the booklet included in delivery for the safety instructions. [. . . ] Before starting the equipment Be sure to read the following information before you use your cordless screwdriver for the first time: 1. Only ever use sharp drill bits and screwdriver bits which are suitable for the purpose and in faultless condition. Always check for concealed electric cables and gas and water pipes when drilling and screwing in walls. 6. Check that your mains voltage is the same as that marked on the rating plate of the battery charger. The red LED will come on to indicate that the battery pack is being charged. The green LED will come on to indicate that charging has been completed. The temperature of the battery pack may rise slightly during the charging operation. If the battery pack fails to become charged, please check whether there is voltage at the socket-outlet whether there is proper contact at the charging contacts on the charger. If the battery still fails to become charged, please return the charger the battery pack to our Customer Service Department. To ensure that the battery pack provides long service, you should take care to recharge it promptly. You must recharge the battery pack when you notice that the power of the cordless screwdriver drops. Anleitung_BT_CD_18_i_SPK7:_ 10. 04. 2008 10:49 Uhr Seite 8 GB gears when the tool has stopped. Set the changeover switch (3) to its centre position whenever you carry out any work (for example changing the tool, maintenance work, etc. ) on the cordless screwdriver. The cordless screwdriver is fitted with a quickaction chuck (2) with an automatic spindle stop. The chuck opening (a) must be large enough to hold the tool (drill bit or screwdriver bit). Set the torque, as described elsewhere in these operating instructions, to suit the size of screw. Replacement part number of the part required For our latest prices and information please go to www. isc-gmbh. info 8. Disposal and recycling The unit is supplied in packaging to prevent its being damaged in transit. This packaging is raw material and can therefore be reused or can be returned to the raw material system. The unit and its accessories are made of various types of material, such as metal and plastic. Cleaning, maintenance and ordering of spare parts Always pull out the mains power plug before starting any cleaning work. 7. 1 Cleaning Keep all safety devices, air vents and the motor housing free of dirt and dust as far as possible. Wipe the equipment with a clean cloth or blow it with compressed air at low pressure. [. . . ] The original guarantee period remains applicable to the device even if repairs are carried out or parts are replaced. In such cases, the work performed or parts fitted will not result in an extension of the guarantee period, and no new guarantee will become active for the work performed or parts fitted. In order to assert your guarantee claim, please send your defective device postage-free to the address shown below. Please enclose either the original or a copy of your sales receipt or another dated proof of purchase. [. . . ]