User manual EINHELL BT-AG 850

[. . . ] wheel diameter: Mounting spindle thread: Protection class: Weight: 230 V ~ 50 Hz 850 W 11000 rpm 115 mm M14 II / ® 1. 7 kg 1. Safety information Please refer to the booklet included in delivery for the safety instructions. Any errors made in following the safety regulations and instructions may result in an electric shock, fire and/or serious injury. Keep all safety regulations and instructions in a safe place for future use. Sound and vibration Sound and vibration values were measured in accordance with EN 60745. [. . . ] The wheel´s rated speed must be higher than the idle speed of the right-angle grinder. Use only grinding and cutting wheels that are approved for a minimum speed of 11000 rpm and a peripheral speed of 80 m/sec. The directional arrow on the diamond cutting wheel must point in the direction in which the tool rotates. 6. 6 OPERATING MODES 6. 6. 1 Rough grinding For the best rough grinding results, hold the grinding wheel at an angle of between 30° and 40° to the workpiece surface and guide back and forth over the workpiece in steady movements. 5. 2 Setting the guard (Fig. Adjust the guard (4) to protect your hands so that the material being ground is directed away from your body. The position of the guard (4) can be adjusted to any specific working conditions. 5. 3 TEST RUN FOR NEW GRINDING WHEELS Allow the right-angle grinder to run in idle for at least 1 minute with the grinding or cutting wheel fitted in place. 4) The angle grinder comes with a safety switch which is designed to prevent accidents. To switch on, push the slide switch (a) to the right while at the same time pushing the ON/OFF switch (2) forwards and depressing. You can then position the angle grinder on the workpiece and machine it. Simple wheel change by spindle lock: Press the spindle lock and allow the grinding wheel to latch in place. 6 Anleitung_BT_AG_850_SPK7:_ 03. 09. 2008 13:03 Uhr Seite 7 GB 6. 6. 2 Cutting When you use the right-angle grinder for cutting purposes, avoid tilting it in the cutting plane. 8. 4 Ordering replacement parts Please quote the following data when ordering replacement parts: Type of machine Article number of the machine Identification number of the machine Replacement part number of the part required For our latest prices and information please go to www. isc-gmbh. info 9. Replacing the power cable If the power cable for this equipment is damaged, it must be replaced by the manufacturer or its aftersales service or similarly trained personnel to avoid danger. The unit is supplied in packaging to prevent its being damaged in transit. This packaging is raw material and can therefore be reused or can be returned to the raw material system. The unit and its accessories are made of various types of material, such as metal and plastic. Cleaning, maintenance and ordering of spare parts Always pull out the mains power plug before starting any cleaning work. 8. 1 Cleaning Keep all safety devices, air vents and the motor housing free of dirt and dust as far as possible. Wipe the equipment with a clean cloth or blow it with compressed air at low pressure. We recommend that you clean the device immediately each time you have finished using it. Do not use cleaning agents or solvents; these could attack the plastic parts of the equipment. [. . . ] The original guarantee period remains applicable to the device even if repairs are carried out or parts are replaced. In such cases, the work performed or parts fitted will not result in an extension of the guarantee period, and no new guarantee will become active for the work performed or parts fitted. In order to assert your guarantee claim, please send your defective device postage-free to the address shown below. Please enclose either the original or a copy of your sales receipt or another dated proof of purchase. [. . . ]