User manual EINHELL BT-AC 200-24 OF

[. . . ] Check moving parts to make sure that they are in good working order and are not jammed or damaged. All parts have to be properly fitted in order to be sure of meeting all the machines requirements. Damaged safety devices and parts have to be repaired or replaced by a customer service workshop unless otherwise stated in this manual. - For your own safety, use only such accessories and auxiliary equipment as are listed in this manual or which are recommended and specified by the manufacturer. [. . . ] Housing cover Pressure vessel Wheel Supporting foot Quick-lock coupling (regulated compressed air) Pressure gauge (for reading the preset tank pressure) Pressure regulator ON/OFF switch Transportation handle Safety valve Drainage screw for condensation water Please note that our equipment has not been designed for use in commercial, trade or industrial applications. Our warranty will be voided if the machine is used in commercial, trade or industrial businesses or for equivalent purposes. The user / operator and not the manufacturer will be liable for any damage or injuries of any kind caused as a result of this. Power supply: Motor rating in kW/HP: Operating mode Compressor speed in rpm: Operating pressure in bar: Pressure vessel volume in litre: Theoretical intake rate in l/min. : Sound power level LWA in dB: Sound pressure level LpA in dB: Protection type: Machine weight in kg: 230 ~ 50 Hz 1. 3 Voltage The compressor is equipped with a mains cable with shock-proof plug. This can be connected to any 230V ~ 50Hz shock-proof socket which is protected by a 16 A fuse. Before you use the machine, make sure that the mains voltage complies with the specifications on the rating plate. In the case of low temperatures below +5°C, motor start-up is jeopardized as a result of stiffness. 1) You can adjust the pressure on the pressure gauge (6) using the pressure regulator (7). 6 Setting the pressure switch The pressure switch is set at the factory. Switch-on pressure 6 bar Switch-off pressure 8 bar You must fully assemble the appliance before using it for the first time. Operating mode S3 - 25% - 10min: S3 = Intermittent mode without influencing the starting process. Report any damage immediately to the company which delivered the compressor. The compressor may only be used in suitable rooms (with good ventilation and an ambient temperature from +5°C to +40°C). there must be no dust , acids , vapors , explosive gases or inflammable gases in the room. It is prohibited to use the compressor in areas where work is conducted with sprayed water. Pull the power plug before doing any cleaning and maintenance work on the appliance. Always depressurize the tank before carrying out any cleaning and maintenance work. 1 Cleaning Keep the safety devices free of dirt and dust as far as possible. Wipe the equipment with a clean cloth or blow it with compressed air at low pressure. We recommend that you clean the appliance immediately after you use it. [. . . ] The original guarantee period remains applicable to the device even if repairs are carried out or parts are replaced. In such cases, the work performed or parts fitted will not result in an extension of the guarantee period, and no new guarantee will become active for the work performed or parts fitted. In order to assert your guarantee claim, please send your defective device postage-free to the address shown below. Please enclose either the original or a copy of your sales receipt or another dated proof of purchase. [. . . ]