User manual EINHELL BG-MT 3336

[. . . ] 7. 15 Anleitung_BG-MT_3336_SPK1:_ 27. 10. 2008 9:33 Uhr Seite 16 GB Important!When using equipment, a few safety precautions must be observed to avoid injuries and damage. Keep this manual in a safe place, so that the information is available at all times. If you give the equipment to any other person, give them these operating instructions as well. [. . . ] Insert the depth stop in the opening at the back of the gear unit and fasten it with the safety split pin (11) at the working height you require (3 positions are available; when using for the first time we would recommend the middle position) (Fig. Stand the power cultivator upright and feed the Bowden wire for the clutch through the lower opening in the holder for the steering handles (Fig. Fit the holder for the steering handles to the engine unit and fasten with the screws (14), the circlip (17) and the washers (16) as shown in Fig. Then fit the steering handles through the openings on the holder for the steering handles and fasten with the screws (13), washers (18) 6. Operation Set the depth stop (4) to the desired depth and secure with the split pin. Swing the transport wheel up and make sure that the bolt is engaged in the notch in the mount at the front. Pull the start cable gently until you feel resistance, then pull vigorously. 17 Anleitung_BG-MT_3336_SPK1:_ 27. 10. 2008 9:33 Uhr Seite 18 GB Depending on how tall you are you can adjust the complete holder for the steering handles to the top position. To start the star-type hoes, press the clutch handle (8) down and hold in this position. Releasing the clutch handle brings the star-type hoes to a stop (if they do not stop, readjust the clutch cable). 7. 2. 3 Changing the oil and checking the oil level (before using the machine) The motor oil is best changed when the motor is at working temperature. Important: Do not screw the dip stick when you check the oil level, simply insert it as far as the thread (H = Max. 7. 2. 4 Adjusting the Bowden wires In the working setting it should be possible to push the clutch lever up to the push bar without this requiring much effort. To do this, undo the lock nut opposite the main cable, extend the screw connector and then tighten the lock nut again (see Fig. If the star-type hoes no longer rotate then the screw connector will have to be shortened again (as described above). 7. 3 Storage Empty the fuel tank before you decommission the unit for a lengthy period of time. Clean the unit and coat all the metal parts with a thin film of oil to prevent them rusting. 7. 4 Ordering spare parts Please provide the following information on all orders for spare parts: Model/type of machine Article number of the machine ID number of the machine Number of the required spare part For our latest prices and information please go to www. iscgmbh. info 7. Cleaning, maintenance, storage and ordering of spare parts Pull out the spark plug boot before doing any cleaning and maintenance work. 7. 1 Cleaning Keep all safety devices, air vents and the motor housing free of dirt and dust as far as possible. Wipe the equipment with a clean cloth or blow it with compressed air at low pressure. We recommend that you clean the device immediately each time you have finished using it. [. . . ] The original guarantee period remains applicable to the device even if repairs are carried out or parts are replaced. In such cases, the work performed or parts fitted will not result in an extension of the guarantee period, and no new guarantee will become active for the work performed or parts fitted. In order to assert your guarantee claim, please send your defective device postage-free to the address shown below. Please enclose either the original or a copy of your sales receipt or another dated proof of purchase. [. . . ]