User manual EINHELL BG-GP 1355 N

[. . . ] The manufacturers warranty does not cover damage caused to the equipment as a result of running it dry. Any errors made in following the safety regulations and instructions may result in an electric shock, fire and/or serious injury. Keep all safety regulations and instructions in a safe place for future use. In stagnant water bodies, garden ponds, swimming ponds and their surrounding areas the unit may only be used with an earth-leakage circuit breaker with an actuating rated current of up to 30 mA (according to VDE 0100 Part 702 and 738). [. . . ] A leaking intake line will draw in air and therefore not draw in any water. 3/4") must be connected to the 1" female thread discharge line connector of the equipment either directly or with the aid of a threaded nipple. With the right couplings it is also possible, of course, to use a 1/2" delivery hose. During the priming operation, fully open any shut-off mechanisms (spray nozzles, valves, etc. ) in the pressure line so that the air can escape without obstruction. Off automatically by the thermostat if overheating occurs and is switched on again automatically after cooling. 2 Storage If the pump is not going to be used for a long time or has to be removed for the winter months, rinse it out with water, empty it completely and allow it to dry. The equipment must be completely drained before it is subjected to frost. After long stoppages, make sure the rotor turns correctly by briefly switching the pump on and off. 3 Ordering replacement parts: Please quote the following data when ordering replacement parts: Type of machine Article number of the machine Identification number of the machine Replacement part number of the part required For our latest prices and information please go to www. The intake process starts automatically; water can be suctioned in for up to 5 minutes (maximum suction height). If the pump is removed again after use, it must always be refilled with water whenever it is connected up and used again. If the power cable for this equipment is damaged, it must be replaced by the manufacturer or its aftersales service or similarly trained personnel to avoid danger. The unit is supplied in packaging to prevent its being damaged in transit. This packaging is raw material and can therefore be reused or can be returned to the raw material system. The unit and its accessories are made of various types of material, such as metal and plastic. In order to ensure a long service life, however, we recommend that you regularly check and care for the product. The equipment must be disconnected from the power supply (pull the power plug) prior to performing any maintenance. 1 Servicing If the equipment becomes clogged, connect the discharge line to the water line and disconnect the suction hose. Replacing the mains cable: Important: Disconnect the equipment from the power supply! a defective mains cable may only be replaced by a qualified electrician. There are no parts inside the equipment which require additional maintenance. [. . . ] Connection to the wrong mains voltage or current type), misuse or inappropriate use (such as overloading of the device or use of non-approved tools or accessories), failure to comply with the maintenance and safety regulations, ingress of foreign bodies into the device (e. Damage caused by the device being dropped) and normal wear resulting from proper operation of the device. The guarantee is rendered null and void if any attempt is made to tamper with the device. The guarantee is valid for a period of 2 years starting from the purchase date of the device. [. . . ]