User manual EINHELL BG-EM 1643

[. . . ] Read and follow the operating instructions and safety information before using for the first time. When using equipment, a few safety precautions must be observed to avoid injuries and damage. It is important to consult these instructions in order to acquaint yourself with the unit, its proper use and safety regulations. Keep this manual in a safe place, so that the information is available at all times. [. . . ] When you fit the top push bar you can decide the height of the push bar by selecting the appropriate fastening hole (Fig. Fasten the top push bar using either the holes L for a low position or H for a high position. Before you fit the grass bag you must ensure that the motor is switched off and the blade is not rotating. 4f / Item 5) and attach the grass box with the other hand as shown in Fig. The user / operator and not the manufacturer will be liable for any damage or injuries of any kind caused as a result of this. Please note that our equipment has not been designed for use in commercial, trade or industrial applications. Our warranty will be voided if the machine is used in commercial, trade or industrial businesses or for equivalent purposes. Adjust the cutting height only when the engine is switched off and the power cable has been disconnected. Before you begin to mow, check to ensure that the blade is not blunt and that none of the fasteners are damaged. To carry out this check, first switch off the motor and pull out the power plug. Never open the discharge flap if the grass box is being emptied and the motor is still running. The safety distance between the blade casing and the user provided by the guide struts must be maintained at all times. Take special care when mowing and changing direction on embankments and slopes. Ensure that you have a secure surface to stand on, wear shoes with anti-slip soles that offer good grip, and long trousers. Do not use the mower on gradients exceeding 15° for safety reasons. 1 Information on correct mowing We recommend that you mow in overlapping lines. Only mow with sharp, perfect blades so that the blades of grass do not fray, making the lawn turn yellow. To achieve a good cut, guide the lawn mower in lines that are as straight as possible. These lines should always overlap by a few centimeters so that you do not leave any strips. During the main growth period (May ­ June), mow it twice a week, and once a week at other times. The cutting height should be between 4 and 6 cm and the growth before the next cut should be between 4 and 5 cm. If the lawn grows longer than this on occasion, do not make the mistake of cutting to normal length straight away since this will damage the lawn. [. . . ] Dear Customer, All of our products undergo strict quality checks to ensure that they reach you in perfect condition. In the unlikely event that your device develops a fault, please contact our service department at the address shown on this guarantee card. Of course, if you would prefer to call us then we are also happy to offer our assistance under the service number printed below. Please note the following terms under which guarantee claims can be made: 1. [. . . ]