User manual EINHELL BG-BC 41

[. . . ] Vor Inbetriebnahme Bedienungsanleitung und Sicherheitshinweise lesen und beachten Read and follow the operating instructions and safety information before using for the first time. Safety Regulations Layout and items supplied Intended use Technical data Assembly Before starting the equipment Operation Cleaning, maintenance and ordering of spare parts Disposal and recycling Troubleshooting When using the equipment, a few safety precautions must be observed to avoid injuries and damage. Please read the complete operating instructions and safety regulations with due care. Keep this manual in a safe place, so that the information is available at all times. [. . . ] DIFFERENT CUTTING METHODS If the machine is correctly assembled with the safety hood and cutting head it will cut weeds and long grass in places with difficult access, for example along fences, walls and foundations and also around trees. It can also be used for mowing work to remove vegetation to allow the better preparation of a garden or to clear a certain area down to the soil. Please note that the statutory regulations governing noise abatement may differ from town to town. 1 Starting the engine when cold Fill the tank with the required amount of oil/petrol mix. Once the engine has started, move the choke lever immediately to " " and allow the machine to warm up for approx. Please note: Since the throttle lever is secured, the cutting tool starts to operate when the engine is started. Then release the throttle lever by simply actuating it (the engine then returns to running in idle mode). Please note: If the engine does not start up even after several attempts, read the section "Engine Troubleshooting". If it is pulled out at an angle, then friction will occur on the eyelet. As a result of this friction, the cable will become frayed and will wear away faster. PLEASE NOTE: Even if it is used carefully, cutting around foundations, stone or concrete walls, etc. tRIMMING / MOWING Swing the trimmer from side to side in a scything motion. Guide and hold the cutting head at the required height to ensure that you cut evenly (Fig. LOWER TRIMMING Hold the trimmer right in front of you at a slight angle so that the underside of the cutter head is above the ground and the line strikes the correct target. CUTTING ALONG FENCES / FOUNDATIONS When cutting approach wire mesh fences, lath fences, natural stone walls and foundations slowly so that you can cut close to them without striking the obstacle with the line. If, for example, the line strikes stones, stone walls or foundations, it will wear or fray. TRIMMING AROUND TREES When trimming around tree trunks, approach slowly so that the line does not strike the bark. Approach grass or weeds with the tip of the line and tilt the cutting head forwards slightly. When doing such work keep a distance of 30 meters between yourself and other people or animals. MOWING For mowing you want to cut all the vegetation down to the ground. Remember the increased risk of injury to the user, watchers and animals and the danger of damaging other items due to objects (for example stones) being thrown out (Fig. The trimmer is a powerful tool and can throw small stones and other objects a distance of 15 meters or more, causing injuries and damage to cars, houses and windows. [. . . ] Dear Customer, All of our products undergo strict quality checks to ensure that they reach you in perfect condition. In the unlikely event that your device develops a fault, please contact our service department at the address shown on this guarantee card. Of course, if you would prefer to call us then we are also happy to offer our assistance under the service number printed below. Please note the following terms under which guarantee claims can be made: 1. [. . . ]