User manual EHEIM ECCO PRO 2034

[. . . ] The "drip loop" is that part of the cord below the level of the receptacle, or the connector if an extension cord is used, to prevent water traveling along the cord and coming in contact with the receptacle. C) Close supervision is necessary when any appliance is used by or near children. D) To avoid injury, do not contact moving parts or hot parts such as heaters, reflectors, lamp bulbs, and the like. E) Always unplug an appliance from an outlet when not in use, before putting on or taking off parts, and before cleaning. [. . . ] Children should be supervised to ensure that they do not play with the equipment. To achieve optimal operational safety there must be a maximum of 150 cm between the surface of the water and the bottom of the filter. Please consult the manuals of medical equipment for the required safety margins. Attention: Maintenance work presents the risk of crushing th fingers due to high magnetic forces. Since a wide variety of varnishes and polishes are used when processing timer, the appliance feet can leave visible traces on furniture or parquet floors as a result of chemical reactions. Therefore the device should not be placed on unprotected wooden surfaces. The product is qualified in accordance with the respective national regulations and guidelines and meets EC standards. For your own protection, it is advisable to make a loop in the electrical cable to catch drips and prevent any water running along the cable from entering the socket. If an extension socket is used, it must be placed above the filter mains connection. Suction and pressure joints » pump head ¿ safety lock ´ sealing ring ² preliminary filter pad ¶ preliminary filter º lid ¾ carbon filter pad µ fine filter pad ¸ filter media containers with filter material ¹ slot multi-function lever filter canister rubber feet pump chamber impeller ball with ball cage pump chamber cover 2 x union nuts 2 x shut-off taps outlet elbow intake pipe with intake strainer suction holders. The shut-off taps are then screwed onto the suction and pressure joints of the filter ­ which can be rotated in the required direction of the hose ­ by means of the threaded sockets ³ and are marked with the stickers IN/OUT (Fig. Then fix the outlet elbow to the aquarium by means of the suction holders. Join the intake pipe with the intake strainer and attach them to the inside of the tank by means of the suction holders (Fig. Cut the hoses to the required lengths and push them onto the intake pipe and outlet elbow for at least 1 cm. Secure hoses at both connections by tightening the union nuts in the direction of the pipe. Note: All hose connections must be checked at regular intervals for correct fitting. The external filter already contains the necessary standard filter material made of special filter pads, a preliminary filter with filter foam, a carbon filter pad and a fine filter pad. Rinse the filter material in the basket und running water until the water runs off clear. When you have finished installing the hose, the device is completely ready for operation. suction function: Now open both shut-off taps on the hose connections (Fig. E) and slowly move down the multifunction lever until it is flush with the safety lock (Fig. As soon as the water begins to flow into the filter canister, slowly move the multi-function lever back to its vertical operating position until it locks noticeably into place (Fig. [. . . ] The layers in the filter inserts are always arranged according to the displayed model (see cover page). From time to time you should clean the pump chamber, ball valve and hoses in order to ensure the perfect functioning of your filter. The pump chamber can be opened by pressing both cover plates together and simultaneously pulling upwards by the bearing (Fig. The pump wheel, chamber, cover and cooling channel are cleaned with a soft brush (order no. [. . . ]