User manual EDOBE XDOM VL58

[. . . ] Do not disassemble any part of the product: the device contains live parts and no userserviceable parts are inside. Adapters: Only connect the adapters to the mains after you have checked whether the mains voltage corresponds with the value on the type tags. Never use old and new batteries or different types of batteries together. Remove the batteries when you are not using the system for a longer period of time. [. . . ] Before fixing the IR emitter firmly you are advised to check if the extender works properly. Therefore point your own remote at the window on the front of the receiver and press some of the channel choose buttons. If the channel does not change, the IR emitter may not be fixed in the right position. Repeat this procedure when fixing the 2nd IR emitter to the other A/V device connected. When the receiver on your TV is connected with RCA plugs and/or a SCART adapter: Switch the TV, to which you have connected the receiver, over to the TV channel, which belongs to the A/V input, on which you have connected the receiver. in case of most appliances , you do that by pressing the 0 or A/V button. The TV will never have to look for channels for the connection via `A/V IN'. When the receiver on your TV is connected to the RF output: Switch the TV, to which you have connected the receiver, over to TV channel 36. The wireless VIDEOLINK usually works best with the flat faces of the antennas on the Transmitter and Receiver unit look at one another. Sometimes however distance, reflections and other effects in the home may affect the signal so that some adjustment of either Transmitter or Receiver antenna may be necessary to get the best signal. if still experiencing difficulty , try changing the "ABCD" channel selector and change channels. Remember though both the receiver and transmitter must be on the same channel. The maximum distance between transmitter and receiver depends on local environmental conditions, but on average the distance is up to 30m, through walls and floors. Connecting to a PC can be done with RCA/RCA on A/V1 as well as RCA/mini-DIN on A/V2. The connector of your graphics card will most likely look as follows: Yellow RCA connector (RCA PHONO Yellow) If your PC is fitted with this connector, the yellow plug of the RCA cable included can be directly connected to the yellow RCA connector of your transmitter. DIN-plug (S-VIDEO) If your graphics card is fitted with the S-VIDEO-connector you cannot directly connect the transmitter to your PC but need an adapter. This adapter `converts' your S-VIDEO signal into a composite video signal. This adapter is usually supplied with the graphics card (or PC) with TVout. [. . . ] Då mottagaren på din TV är ansluten till RF utgången: Slå på TV:n som du anslutit till mottagaren och ställ in kanal 36. Du kan ansluta till din PC med RCA/RCA till A/V1 likväl som med RCA/mini-DIN till A/V2. Ställ in den mottagande TV:n till den TV mottagning som är ansluten till A/V ingången. Se till så att enheterna är anslutna till ett eluttag och att power knappen är inställd på "På" läget. [. . . ]