User manual EDOBE XDOM TPC

[. . . ] Important: the product must be used according the instructions in this manual and is not suitable for other purposes. Please avoid the following: strong mechanical wear and tear, high temperature, strong vibrations, and high humidity. [. . . ] The factory setting will be "1 = 1 GREEN Blink" After setting the UNIT Code, the YELLOW LED will blink 3 times, which means the UNITE Code is set and the module has leave the program mode. For "B3" the red LED will blink twice for the house code and then green 3 times for the unit code. Wait until the LED blinks yellow 3 times to show it has left the programming mode. NOTE : If the remote control is assigned to several ebode receivers, each push on the On/Off key will activate all receivers set to the same address. First row: A brief press on the ON button, receivers with the same address will power on or open (when used with shutter). A brief press on the OFF button, receivers with the same address will power off or close (when used with shutter). Second row: A brief press of the ON button, receivers with the same address will power on or open (when used with shutter). A brief press of the OFF button, receivers with the same address will power off or close (when used with shutter). Dimming function : A long push on either key of the remote enables dimming function as long as a dimmer receiver is set on same address. To properly position a motorized shutter/ Home Cinema screen along with the RMV receiver, just press once "up or down" followed by another push on the same key to stop at the desired position. INFO LED lamporna visar följande lägen: Röd LED för Huskoden (A till P) Grön LED för Enhetskoden (1 till 16) Gul status för att gå in i eller lämna programmeringsläget A. Dès maintenant commander à distance (récepteur réglé sur les voies A1 et A2): a) Les récepteurs RMA, RMV, RPT, RPA, RPL (rappel: les récepteurs RPA et RPL nécessitent la présence d'un convertisseur d'ordre radio vers courant porteur). [. . . ] New stylish RF remote to control any ebode or X10 compatible RF receiver. In-Wall Modules Product EMML RMML PMML Description 2-position RF in-wall module to install behind any mechanical wall switch. [. . . ]