User manual EDOBE XDOM TAKE 6 IR

[. . . ] General Security Note Attention: For carefree and safe use of this product, please read this manual and safety information carefully and follow the instructions. Technical manipulation of the product or any changes to the product are forbidden, due to security and approval issues. Please take care to set up the device correctly - consult your user guide. Important: the TAKE 6 must be used according the instructions in this manual and is not suitable for other purposes. [. . . ] Repeat this procedure from step 1 for the other equipment you want to control (DVR, DVD, STB, . If it still doesn't respond, try the manual code search method (4. Automatic code search for some well-known brands If your brand is listed hereafter, you can use the brand search method (faster than the "manual" and the "automatic code search"). Enter the code corresponding to your brand, point the TAKE 6 Remote in the direction of your equipment, press CHAN+ (6) once only. Continue to point the TAKE 6 Remote at your equipment until the equipment changes Channel (the remote control sends an IR signal every second. If you accidentally miss the code, you can stop the autosearch by pressing CHAN- (6) and by repeatedly pressing this key return to the right code. 3 Automatic code search for all brands When searching an unknown code, you can step through the library automatically (AutoSearch). When your equipment responds, you can stop the searching process and store the code you found. ) to DVR, DVD, CD, STB, AUDIO or AUX key, you need first to enter any 4-digit code for the kind of appliance you wish to control (found in the code book), i. : If you want to program a STB under the DVR key, enter ANY STB code found in the code book and then follow the steps below: 1. After a few seconds the remote starts stepping through the code library (fast search, 1 code per second). When the device responds, you can press CHAN+ (6) to switch to slow search (1 code per 3 seconds). You can step back by pressing CHAN- (6) (you can step forward by pressing CHAN+ (6) in case you went too far back). As soon as the device responds again, press the -/-- key (13) to store the code you found. Remark: if some functions of your equipment don't work, you need to try another code for your brand. For example, if it was 030, the search function starts at 031, and it will keep on trying until the last possible code. 4 Manual code search Note: as you can dedicate any appliance TV, DVR, DVD, STB, AUDIO, AUX, keys, you first need to enter any 4-digit code for the kind of appliance you wish to control (found in the code book), i. Under the AUX key, enter ANY STB code found in the code book and then follow the steps below: 1. Press the mode key (4) that matches the equipment you want to control (for example TV). If you step past the correct code use CHAN- (6) to go back to the right code. When the equipment you want to control reacts, press -/-- (13) to confirm the code. Note: If your equipment doesn't have CHAN+ you can use PLAY (DVR or DVD) (15) or POWER (1) key. [. . . ] You don't even have to remember which TV station is on which button, as the brightly displayed icons on the fullcolour LCD display make it easy to find and surf all the channels, plus your own favourite 'personal' buttons for you and your partner also give you quick access to all your own favourite channels too. The remote can be set-up within 5 minutes and is very easy to use and navigate. As the TAKE10 features RF control, you can even control equipment which is out of sight - even through doors, walls and ceilings. If you have always wanted to distribute audio and video to a second room but have avoided doing so because of the cost and difficulties surrounding running cables, the easy answer has arrived. [. . . ]