User manual EDOBE XDOM RMV

[. . . ] Important: the product must be used according the instructions in this manual and is not suitable for other purposes. Please avoid the following: strong mechanical wear and tear, high temperature, strong vibrations, and high humidity. please also respect the additional security notes in the various user guide chapters. [. . . ] Press and hold the PROG key till LED lights up green (after 3 seconds). Press/release minimum 10 times the key PROG, the LED starts blinking for 5 times then to blink off. Just put on again the paddle (make sure ebode logo is located on the bottom right side). This procedure consists of erasing all addresses you may entered over time which are not valid to control your Home Automation system. Press and hold the PROG key till LED lights up green (after 3 seconds). Both green and red LEDS blinks quickly on, to turn off after several seconds (LED to blink orange). All addresses are now erased, receiver goes back in X10 standard communication protocol. Put on again the paddle (make sure ebode logo is located on the bottom right side). Use a X10 compatible remote control, RF wall switch or programmer to check remote control of the shutter, roll blind or motorized screen. RMV cannot be controlled anymore from either an RF or PLC remote/ programmer?- Go for an overall RESET of the receiver as it may have lost the address due to too many manipulations (starts from point 5), then re-initialize transmitter and receiver RMV both together (starts from point 3). Red or Green LED blinks randomly even if no commands are given: RF or PLC interference may occur (ie Fluo lamps, Reversible A/C, PC monitor) please add either a filter FD10 in the main control panel or a plug in module FM10 to filter the product in cause. Följande procedur är för att lära en (eller till och med fler än en) adress från sändare till RMV mottagaren. NOTERA : För korrekt installation, se till så att ebode loggan visas på pedalen nere till höger. [. . . ] Control your appliance or lamps etc, via any ebode or X10 compatible controller via PLC AND RF!New stylish RF remote to control any ebode or X10 compatible RF receiver. In-Wall Modules Product EMML RMML PMML Description 2-position RF in-wall module to install behind any mechanical wall switch. [. . . ]