User manual EDOBE XDOM PMML

[. . . ] Important: the product must be used according the instructions in this manual and is not suitable for other purposes. Please avoid the following: strong mechanical wear and tear, high temperature, strong vibrations, and high humidity. please also respect the additional security notes in the various user guide chapters. To ensure correct set up please read the manual and security notes carefully. [. . . ] 1 HOW TO PROGRAM THE MICRO TRANSMITTER In order to add the Micro Transmitter to a different installation from the original one, or to one with interference from a nearby system, it is necessary to program a different code. The programming address is made up of a "HOUSE" code (from A through P) and of a "UNIT" code (from 1 through 16). The factory default address of the transmitter/receiver pair is set at A1. Then the LED lights up RED once (for the HOUSE CODE), then GREEN once (for the UNIT code). - Press the (1) button as many times as needed to get to the desired HOUSE CODE and then release it. - After having set the HOUSE CODE, the LED will flash YELLOW 3 times to confirm the code has been memorized and exit from programming mode. - Press the (0) button as many times as needed to get to the desired UNIT CODE and then release it. 2 HOW TO PROGRAM THE MICRO RECEIVER The Micro Transmitter commands must be recognized in order to add the Micro Receiver to a different installation from the original or to one with interference from a nearby system. Press down and hold the button in the (PROG) opening with a paper clip until the LED lights up GREEN, then release it. The LED will flash GREEN and wait for a command from a Micro Transmitter or remote control switch. REMARKS The RMML Micro Receiver will remember as many Micro-Transmitters and remote control switches as necessary. Om du Vill lägga till andra Mikrosändare, Mikromottagare eller fjärrkontroller till ditt installerade system så kan du välja mellan följande lösningar: -Lägg till ett eller flera kommandopunkter för att skapa ett tvåvägsreglage: Installera Mikrosändaren (na) så som beskrivs i manualen -Lägg till en fjärrkontroll till systemet: Den första radens knappan kontrollerar automatiskt belysningen. ANMÄRKNINGAR Med en enkel installation så är ingen ytterligare programmering nödvändig för att lägga till en eller flera Mikromoduler och en fjärrkontroll till systemet. 1 HUR DU PROGRAMMERAR MIKROSÄNDAREN För att lägga till Mikrosändaren till en annan installation än den första, eller till en installation med störningar från ett närliggande system, är det nödvändigt att programmera en annan kod. Programmeringsadressen består av en "Huskod" (från A till P) och en "Enhetskod" (från 1 till 16). 2 HUR DU PROGRAMMERAR MIKROMOTTAGAREN Mikrosändarens kommandon måste kännas igen för att lägga till Miromottagaren till en annan installation än den utsprungliga eller till ett sytem med störningar från andra system. CE DECLARATION OF CONFORMITY UK - We, BMB Electronics BV, Kortakker 10 ­ 4264 AE Veen ­ The Netherlands, herewith declare that the following designated product PMML, is in compliance with the essential requirements and other relevant provisions of Directive 1999/5/EC. Device: The use of the symbol indicates that this The use of the symbol indicates that this product may not be treated as h product may not be treated as household Device: product disposed waste. [. . . ] Ideal for retro fit installations, the classic X10 plugin module in a new and stylish jacket. Control your appliance or lamps etc, via any ebode or X10 compatible controller via PLC AND RF!New stylish RF remote to control any ebode or X10 compatible RF receiver. In-Wall Modules Product EMML RMML PMML Description 2-position RF in-wall module to install behind any mechanical wall switch. [. . . ]