User manual EDOBE XDOM PM10C

[. . . ] Please take care to set up the device correctly - consult your user guide. No guarantee or liability will be accepted for any damage caused due to incorrect use of the equipment supplied, other than indicated in this owner's manual. To prevent short circuits, this product (except if specified for outdoor usage) should only be used inside and only in dry spaces. [. . . ] Plug the PowerMid Transmitter (ST10) power supply adapter into a 230V~ outlet in the room where you want to use your remote control (up to 20 feet/6 meters away from where you normally sit). Plug the power supply adapter lead plug into the socket on the rear of the ST10. Plug the PowerMid Receiver (RE10) power supply adapter into a 230V~ outlet in the room where your TV, VCR, Stereo, etc. Plug the power supply adapter lead plug into the socket on the rear of the RE10. The Receiver then re-transmits these infrared signals to your TV, VCR, stereo, etc. Expanding the system -Add more Transmitters to use your remote controls in several rooms. -Add an Infrared Extender (sold separately) if you need to place the PowerMid Receiver next to your equipment instead of in front of it, or if your equipment is located inside a closed cabinet. Troubles shooting Note: The Transmitter and Receiver will most likely be in different rooms (up to 30 meters away). The number of floors and walls the signal has to travel through and material these walls and floors are made of. The best range will be achieved when these sources are switched off while using the PowerMid. Some satellite receivers require more careful positioning of the PowerMid system. If any difficulty is encountered, try to move the PowerMid (Receiver) a little to various positions until it operates correctly. När du trycker på en knapp, fångar sändaren IR-kommandot, omvandlar den till ett RF-meddelande och vidarebefordrar den igenom väggarna till PowerMid Receiver (RE10). DECLARATION OF CONFORMITY Hereby, ebode declares that this PM10C is in compliance with the essential requirements and other relevant provisions of the following Directives: 1) Directive 1999/5/EC of the European Parliament and of the Council of 9 March 1999 on radio equipment and telecommunications terminal equipment and the mutual recognition of their conformity 2) Directive 2004/108/EC of the European Parliament and of the Council of 15 December 2004 on the approximation of the laws of the Member States relating to electromagnetic compatibility 3) Directive 2006/95/EC of the European Parliament and of the Council of 12 December 2006 on the harmonization of the laws of Member States relating to electrical equipment designed for use within certain voltage limits 4) Directive 2002/95/EC of the European Parliament and of the Council of 27 January 2003 on the restriction of the use of certain hazardous substances in electrical and electronic equipment 5) Directive 2005/32/EC of the European Parliament and of the Council of 6 July 2005 establishing a framework for the setting of eco design requirements for energy-using Technical data and copies of the original Declaration of Conformity are available and can be obtained from ebode electronics: PB 25, NL-4264ZG, the Netherlands. [. . . ] Ideal for retro fit installations, the classic X10 plugin module in a new and stylish jacket. Control your appliance or lamps etc, via any ebode or X10 compatible controller via PLC AND RF!New stylish RF remote to control any ebode or X10 compatible RF receiver. [. . . ]