User manual EDOBE XDOM IR LINK P

[. . . ] Technical manipulation of the product or any changes to the product are forbidden, due to security and approval issues. Please take care to set up the device correctly - consult your user guide. [. . . ] They allow control of IR remote controlled audio/video components (such as your A/V Receiver, DVR, satellite box, cable tuner, etc. ) and are attached to the IR sensor "window" on such components by a self adhesive film. When a handheld remote control is operated and aimed at the ebode IR Link P, the IR commands will be passed to the controlled equipment. Most brands and models of IR controlled equipment are usable with your ebode IR Link P, with some exceptions like those using high frequency IR carriers, such as Bang & Olufsen (ask your dealer). Installing the ebode IR Link P The Hub sockets are colour coded for easy plug & play installation of the IR Receiver and IRED Emitters, which have coloured jacks. Step 1: Place the ebode IR Link P IR Receiver in any convenient location so that the InfraRed beam from your remote control has a direct view to the front of the unit (within range of the device (4-7 meters)). The Receiver can be fixed to the surface by using the double side tape pad or via a slide on screw hole on the bottom of the unit. Step 2: Install the small Emitters onto your controlled components, using the following procedure: Remove the paper backing from one of the Emitters, exposing the adhesive surface. Apply the Emitter directly onto the centre of the sensor "window" on one of your components. Test the position of the IR Emitters first, before you finally stick them onto the eye. Connect additional IRED Emitters to the corresponding jack of the Hub, and install the small Emitters onto your controlled components as per the procedure above. Step 3: Run the wire of the IR Receiver through the back of your cabinet and plug the jack into the correct socket of the Hub. Step 4: Plug the power supply adapter into the little Hub power connection. TIP: You can also stick the IR Receiver to the bottom or side of the cabinet using the double-sided tape, or screw it to the bottom of the cupboard using the screw hole at the bottom of the Receiver. [. . . ] The symbol indicates that this product should be disposed of separately from regular household waste streams. It is your responsibility to dispose of this and other electric and electronic equipment via designated collection facilities appointed by the government or local authorities. [. . . ]