User manual EDOBE XDOM IR LINK C

[. . . ] Remove the batteries when you are not using the system for a longer period of time. Make sure that the batteries are not short circuited and are not disposed in fire (danger of explosion). In case of improper usage or if you have opened, altered and repaired the product yourself, all guarantees expire. [. . . ] If it isn't, run a single length of RG59 or preferably RG6 cable from the Main Room to the Remote Room. NOTE: If RF amplifier(s), splitters or taps are used anywhere in the line of the coaxial cable between the CPL Coupler and the INJ Injector, you must verify if those are DC passive in order to be sure to route the IR commands through the amplifier(s) and splitters. Plug the power supply into a 230V~50Hz outlet after you have made all other connections. Position the IRLP IR Receiver so that the InfraRed beam from the handheld remote control has a direct view at the front of the unit (within 10m). The Receiver can be fixed to the surface by using the double side tape pad or via a slide on screw hole on the bottom of the unit. INSTALLING THE INJ INJECTOR Insert the "TO TV" plug on the back of the INJ Injector into "RF IN" on the TV in the Remote Room. connect the room-to-room cable to "ANT INPUT" on the INJ Injector. INSTALLING THE CPL COUPLER Insert the "SAT/VCR" plug on the back of the CPL Coupler into "OUT TO TV" on DVR in the main room. The emitters should be installed directly to the InfraRed sensor "window" on the front panel of the satellite Receiver, DVR, cable box, etc. Simply remove the paper backing exposing the adhesive surface of each Emitter and apply them to the centre of the sensor window. NOTE: Although the IRED appears dark to the eye, it is transparent to InfraRed. Positioning the IRED directly over the InfraRed window(s) of the component(s) will not block direct IR control from a handheld remote. ATTENTION: If you are only using one A/V appliance, then you do not need to use the additional IR Emitters. Operation To use the ebode IR Link C Remote Control Extension System, simply point your handheld remote control(s) at the IR Receiver and press the desired button. [. . . ] Fornisce una riproduzione accurata dei codici a InfraRossi che vengono utilizzati nei telecomandi di ultima generazione, per esempio, nelle set-top box e nei media player (incl. DECLARATION OF CONFORMITY Hereby, ebode electronics, declares that this ebode IR Link C is in compliance with the essential requirements and other relevant provisions of the following Directives: Directive 2004/108/EC of the European Parliament and of the Council of 15 December 2004 on the approximation of the laws of the Member States relating to electromagnetic compatibility Directive 2006/95/EC of the European Parliament and of the Council of 12 December 2006 on the harmonization of the laws of Member States relating to electrical equipment designed for use within certain voltage limits Directive 2002/95/EC of the European Parliament and of the Council of 27 January 2003 on the restriction of the use of certain hazardous substances in electrical and electronic equipment Directive 2005/32/EC of the European Parliament and of the Council of 6 July 2005 establishing a framework for the setting of eco design requirements for energy-using Technical data and copies of the original Declaration of Conformity are available and can be obtained from ebode electronics: PB 25, NL-4264ZG, the Netherlands. User Information for Consumer Products Covered by EU Directive 2002/96/EC on Waste Electric and Electronic Equipment (WEEE) This document contains important information for users with regards to the proper disposal and recycling of ebode products. [. . . ]